Messages in this thread Patch in this message | | | From | Arnd Bergmann <> | Subject | [PATCH] mtd: cfi: enforce valid geometry configuration | Date | Mon, 23 Nov 2015 14:39:33 +0100 |
| |
MTD allows compile-time configuration of the possible CFI geometry settings that are allowed by the kernel, but that includes a couple of invalid configurations, where no bank width or no interleave setting is allowed. These are then caught with a compile-time warning:
include/linux/mtd/cfi.h:76:2: warning: #warning No CONFIG_MTD_CFI_Ix selected. No NOR chip support can work. include/linux/mtd/map.h:145:2: warning: #warning "No CONFIG_MTD_MAP_BANK_WIDTH_xx selected. No NOR chip support can work"
This is a bit annoying for randconfig tests, and can be avoided if we change the Kconfig logic to always select the simplest configuration when no other one is enabled.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
diff --git a/drivers/mtd/chips/Kconfig b/drivers/mtd/chips/Kconfig index 63b6b536b044..741ec69e0b46 100644 --- a/drivers/mtd/chips/Kconfig +++ b/drivers/mtd/chips/Kconfig @@ -69,6 +69,10 @@ endchoice config MTD_CFI_GEOMETRY bool "Specific CFI Flash geometry selection" depends on MTD_CFI_ADV_OPTIONS + select MTD_MAP_BANK_WIDTH_1 if !(MTD_MAP_BANK_WIDTH_2 || \ + MTD_MAP_BANK_WIDTH_4 || MTD_MAP_BANK_WIDTH_8 || \ + MTD_MAP_BANK_WIDTH_16 || MTD_MAP_BANK_WIDTH_32) + select MTD_CFI_I1 if !(MTD_CFI_I2 || MTD_CFI_I4 || MTD_CFI_I8) help This option does not affect the code directly, but will enable some other configuration options which would allow you to reduce
| |