Messages in this thread | | | Date | Fri, 20 Nov 2015 10:41:08 -0800 | From | Stephen Boyd <> | Subject | Re: [PATCH v3 1/1] clk: si5351: Add PLL soft reset |
| |
On 11/20, Jacob Siverskog wrote: > This is according to figure 12 ("I2C Programming Procedure") in > "Si5351A/B/C Data Sheet" > (https://www.silabs.com/Support%20Documents/TechnicalDocs/Si5351-B.pdf). > > Without the PLL soft reset, we were unable to get three outputs > working at the same time. > > According to Silicon Labs support, performing PLL soft reset will only > be noticeable if the PLL parameters have been changed. > > Signed-off-by: Jacob Siverskog <jacob@teenage.engineering> > Signed-off-by: Jens Rudberg <jens@teenage.engineering> > Acked-by: Sebastian Hesselbarth <sebastian.hesselbarth@gmail.com> > ---
Applied to clk-next
-- Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum, a Linux Foundation Collaborative Project
| |