lkml.org 
[lkml]   [2015]   [Oct]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFT 1/3] dt-bindings: usb: usb5303: Document new 'phys' property
Date
Document new 'phys' and 'phys-names' properties.

Signed-off-by: Krzysztof Kozlowski <k.kozlowski@samsung.com>
Cc: Kevin Hilman <khilman@kernel.org>
Cc: Arnd Bergmann <arnd@arndb.de>
Cc: riku.voipio@linaro.org
Cc: Marek Szyprowski <m.szyprowski@samsung.com>
---
Documentation/devicetree/bindings/usb/usb3503.txt | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/Documentation/devicetree/bindings/usb/usb3503.txt b/Documentation/devicetree/bindings/usb/usb3503.txt
index 52493b1480e2..773c8d722c13 100644
--- a/Documentation/devicetree/bindings/usb/usb3503.txt
+++ b/Documentation/devicetree/bindings/usb/usb3503.txt
@@ -15,6 +15,8 @@ Optional properties:
- reset-gpios: Should specify GPIO for reset.
- initial-mode: Should specify initial mode.
(1 for HUB mode, 2 for STANDBY mode)
+- phys: One PHY specifier (refer to generic PHY bindings).
+- phy-names: If 'phys' is present, then it must be 'usb2-phy'.
- refclk: Clock used for driving REFCLK signal (optional, if not provided
the driver assumes that clock signal is always available, its
rate is specified by REF_SEL pins and a value from the primary
@@ -33,4 +35,6 @@ Examples:
intn-gpios = <&gpx3 4 1>;
reset-gpios = <&gpx3 5 1>;
initial-mode = <1>;
+ phys = <&usb2_phy_gen 3>;
+ phy-names = "usb2-phy";
};
--
1.9.1


\
 
 \ /
  Last update: 2015-10-07 02:41    [W:0.149 / U:0.172 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site