lkml.org 
[lkml]   [2015]   [Oct]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 4/4] arm64: dts: Add BRCM IPROC NAND DT node for NS2
From
Date


On 16/10/15 10:08, Anup Patel wrote:
> The NAND controller on NS2 SoC is compatible with existing
> BRCM IPROC NAND driver so let's enable it in NS2 DT and
> NS2 SVK DT.
>
> Signed-off-by: Anup Patel <anup.patel@broadcom.com>
> Reviewed-by: Ray Jui <rjui@broadcom.com>
> Reviewed-by: Scott Branden <sbranden@broadcom.com>
> ---
> arch/arm64/boot/dts/broadcom/ns2-svk.dts | 12 ++++++++++++
> arch/arm64/boot/dts/broadcom/ns2.dtsi | 14 ++++++++++++++
> 2 files changed, 26 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/broadcom/ns2-svk.dts b/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> index e5950d5..a754160 100644
> --- a/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> +++ b/arch/arm64/boot/dts/broadcom/ns2-svk.dts
> @@ -63,5 +63,17 @@
> uart3: serial@66130000 {
> status = "ok";
> };

Better to change even the above reference, see below.

> +
> + nand: nand@66460000 {

In most of the cases where such static overlays are done, I have seen
the labels being used to refer back the node. Using the complete node
name again is kind of inviting trouble as even minor typo results in
creation of another node.

--
Regards,
Sudeep


\
 
 \ /
  Last update: 2015-10-20 11:21    [W:0.101 / U:0.564 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site