Messages in this thread | | | Date | Fri, 16 Oct 2015 18:55:21 +0300 | Subject | Re: [PATCH v2] spi: Setup the master controller driver before setting the chipselect | From | Andy Shevchenko <> |
| |
On Fri, Oct 16, 2015 at 6:47 PM, Franklin S Cooper Jr. <fcooper@ti.com> wrote: > > > On 10/16/2015 10:45 AM, Andy Shevchenko wrote: >> On Fri, Oct 16, 2015 at 6:29 PM, Franklin S Cooper Jr <fcooper@ti.com> wrote: >>> SPI controllers may need to be properly setup before chip selects >>> can be used. Therefore, wait until the spi controller has a chance >>> to perform their setup procedure before trying to use the chip >>> select. >>> >>> This also insures that the chip selects pins are in a good >>> state before asseting them which otherwise may cause confusion. >>> >>> Signed-off-by: Franklin S Cooper Jr <fcooper@ti.com> >> Does it mean I have to test it again? > Oops sorry. No the patch hasn't changed. I can shoot a v3 with your tested by included.
Whatever Mark prefers.
-- With Best Regards, Andy Shevchenko
| |