lkml.org 
[lkml]   [2014]   [Sep]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC] iommu/vt-d: Use the SIRTP when enabling remapping
Date
The previous change (iommu/vt-d: Don't store SIRTP request) to this area
caused a crash in our simulator. In particular is seems that by the time a
UART interrupt is sent through the system, we don't see interrupt remapping
to be enabled. So the interrupt does not get translated to a logical
interrupt and crashes.

OR'ing the SIRTP request to make sure it is seen but hopefully not sticky.
This seems like a clean fix, at least on our simulator; if you don't agree,
our simulator guy will take a closer look at our iommu model.

Found testing on our simulator, not real hardware.

Signed-off-by: Nathan Zimmer <nzimmer@sgi.com>
Signed-off-by: Gary Kroening <gfk@sgi.com>
Cc: Jan Kiszka <jan.kiszka@siemens.com>
Cc: Joerg Roedel <jroedel@suse.de>

---
drivers/iommu/intel_irq_remapping.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/iommu/intel_irq_remapping.c b/drivers/iommu/intel_irq_remapping.c
index a872874..f586e41 100644
--- a/drivers/iommu/intel_irq_remapping.c
+++ b/drivers/iommu/intel_irq_remapping.c
@@ -455,7 +455,7 @@ static void iommu_set_irq_remapping(struct intel_iommu *iommu, int mode)
/* Enable interrupt-remapping */
iommu->gcmd |= DMA_GCMD_IRE;
iommu->gcmd &= ~DMA_GCMD_CFI; /* Block compatibility-format MSIs */
- writel(iommu->gcmd, iommu->reg + DMAR_GCMD_REG);
+ writel(iommu->gcmd | DMA_GCMD_SIRTP, iommu->reg + DMAR_GCMD_REG);

IOMMU_WAIT_OP(iommu, DMAR_GSTS_REG,
readl, (sts & DMA_GSTS_IRES), sts);
--
1.8.2.1



\
 
 \ /
  Last update: 2014-09-09 23:41    [W:0.855 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site