lkml.org 
[lkml]   [2014]   [Sep]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectGPIO registration for external Ethernet PHY oscillator enable/disable
I have some questions that span multiple subsystems including
gpio/pinctrl, apm, and net subsystems.

On some of our system on module designs, we use a GPIO to toggle the
enable pin on external oscillators. In particular, we are using a 50Mhz
oscillator to drive a clock on a RMII Ethernet PHY.

Though I can configure the pin such that the Ethernet interface works we
are looking to disable the oscillator during APM sleep but after the PHY is
put into a low power mode.

How do I register a GPIO for use in the PHY suspend and resume code?
Can it be handled outside of the PHY driver?
If so how do ensure the appropriate suspend and resume sequencing?

For reference, we are using a Micrel KSZ8081 PHY connected to a
AT91SAMA5D35 processor.


\
 
 \ /
  Last update: 2014-09-24 00:21    [W:0.071 / U:0.256 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site