lkml.org 
[lkml]   [2014]   [Aug]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/5] ARM: Berlin: Ethernet support
Date
Hi all,

This series introduce the Marvell Berlin Ethernet driver, allowing to
handle the fast Ethernet port. This driver is based on the mv643xx_eth
driver and reuse some of its functions. While I wanted to make these
functions common to the two drivers at first, I finally do think this
is not a great idea:
- Registers are very different.
- The mv643xx_eth supports up to 1000Mbps interfaces and performance
issues may occur, whereas the mvberlin_eth is only for fast Ethernet.
- The mvberlin_eth driver uses a hash table to filter incoming packets.
- A few other differences.

I tried to stay close to the mv643xx_eth implementation, so that the
discussion is still open, but I still ended up with lots of tiny
differences that can be hard to manage for both cases. In the end I do
think having two separate drivers is a good choice.

That being said, I tested the Ethernet communication with ICMP pings,
netcat, tried to use some network related softwares (such as ssh). Here
is an iperf output:

------------------------------------------------------------
Client connecting to 192.168.0.11, TCP port 5001
TCP window size: 85.0 KByte (default)
------------------------------------------------------------
[ 3] local 192.168.0.20 port 44183 connected with 192.168.0.11 port 5001
[ ID] Interval Transfer Bandwidth
[ 3] 0.0-10.0 sec 113 MBytes 94.8 Mbits/sec

Tests were done on a BG2Q DMP, and this series currently does not add
other device tree nodes than the ones for this board.

Thanks!

Antoine


Antoine Tenart (5):
net: mvberlin_eth: add an Ethernet driver for Marvell Berlin
Documentation: bindings: net: add the Marvell Berlin Ethernet
controller
Documentation: devicetree: net: mention Marvell Berlin
ARM: dts: berlin: add ethernet and mdio nodes
ARM: dts: berlin: enable the Ethernet port on the BG2Q DMP

.../devicetree/bindings/net/marvell-berlin.txt | 23 +
.../devicetree/bindings/net/marvell-orion-mdio.txt | 6 +-
arch/arm/boot/dts/berlin2q-marvell-dmp.dts | 13 +
arch/arm/boot/dts/berlin2q.dtsi | 19 +
drivers/net/ethernet/marvell/Kconfig | 9 +
drivers/net/ethernet/marvell/Makefile | 1 +
drivers/net/ethernet/marvell/mvberlin_eth.c | 2081 ++++++++++++++++++++
7 files changed, 2149 insertions(+), 3 deletions(-)
create mode 100644 Documentation/devicetree/bindings/net/marvell-berlin.txt
create mode 100644 drivers/net/ethernet/marvell/mvberlin_eth.c

--
1.9.1



\
 
 \ /
  Last update: 2014-08-29 16:21    [W:0.125 / U:0.296 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site