lkml.org 
[lkml]   [2014]   [Jul]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/1] ahci: st: Provide DT bindings for ST's SATA implementation
Date
Cc: devicetree@vger.kernel.org
Cc: Srinivas Kandagatla <srinivas.kandagatla@st.com>
Acked-by: Alexandre Torgue <alexandre.torgue@st.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>
---

Hi Tejun,

This patch has been on the MLs for a few months now. It documents
ST's AHCI driver which was accepted by you and now resides in
Mainline.

Kind regards,
Lee

Documentation/devicetree/bindings/ata/ahci-st.txt | 31 +++++++++++++++++++++++
1 file changed, 31 insertions(+)
create mode 100644 Documentation/devicetree/bindings/ata/ahci-st.txt

diff --git a/Documentation/devicetree/bindings/ata/ahci-st.txt b/Documentation/devicetree/bindings/ata/ahci-st.txt
new file mode 100644
index 0000000..0574a77
--- /dev/null
+++ b/Documentation/devicetree/bindings/ata/ahci-st.txt
@@ -0,0 +1,31 @@
+STMicroelectronics STi SATA controller
+
+This binding describes a SATA device.
+
+Required properties:
+ - compatible : Must be "st,sti-ahci"
+ - reg : Physical base addresses and length of register sets
+ - interrupts : Interrupt associated with the SATA device
+ - interrupt-names : Associated name must be; "hostc"
+ - resets : The power-down and soft-reset lines of SATA IP
+ - reset-names : Associated names must be; "pwr-dwn" and "sw-rst"
+ - clocks : The phandle for the clock
+ - clock-names : Associated name must be; "ahci_clk"
+ - phys : The phandle for the PHY device
+ - phy-names : Associated name must be; "ahci_phy"
+
+Example:
+
+ sata0: sata@fe380000 {
+ compatible = "st,sti-ahci";
+ reg = <0xfe380000 0x1000>;
+ interrupts = <GIC_SPI 157 IRQ_TYPE_NONE>;
+ interrupt-names = "hostc";
+ phys = <&miphy365x_phy MIPHY_PORT_0 MIPHY_TYPE_SATA>;
+ phy-names = "ahci_phy";
+ resets = <&powerdown STIH416_SATA0_POWERDOWN>,
+ <&softreset STIH416_SATA0_SOFTRESET>;
+ reset-names = "pwr-dwn", "sw-rst";
+ clocks = <&clk_s_a0_ls CLK_ICN_REG>;
+ clock-names = "ahci_clk";
+ };
--
1.8.3.2


\
 
 \ /
  Last update: 2014-07-21 11:01    [W:0.044 / U:4.572 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site