Messages in this thread Patch in this message | | | From | Graham Williams <> | Subject | [PATCH] regulator: bcm590xx: fix vbus name | Date | Wed, 18 Jun 2014 12:42:10 -0700 |
| |
The vbus regulator was not getting its name set. This results in the sysfs entry being empty. The lack of a bcm590xx_regs[] table entry also upsets Coverity runs. Add the table entry so the name gets set properly.
Signed-off-by: Graham Williams <graham.williams@linaro.org> --- drivers/regulator/bcm590xx-regulator.c | 5 +++++ 1 file changed, 5 insertions(+)
diff --git a/drivers/regulator/bcm590xx-regulator.c b/drivers/regulator/bcm590xx-regulator.c index 57544e2..58ece59 100644 --- a/drivers/regulator/bcm590xx-regulator.c +++ b/drivers/regulator/bcm590xx-regulator.c @@ -119,6 +119,10 @@ static const unsigned int ldo_c_table[] = { 2900000, 3000000, 3300000, }; +static const unsigned int ldo_vbus[] = { + 5000000, +}; + /* DCDC group CSR: supported voltages in microvolts */ static const struct regulator_linear_range dcdc_csr_ranges[] = { REGULATOR_LINEAR_RANGE(860000, 2, 50, 10000), @@ -192,6 +196,7 @@ static struct bcm590xx_info bcm590xx_regs[] = { BCM590XX_REG_TABLE(gpldo4, ldo_a_table), BCM590XX_REG_TABLE(gpldo5, ldo_a_table), BCM590XX_REG_TABLE(gpldo6, ldo_a_table), + BCM590XX_REG_TABLE(vbus, ldo_vbus), }; struct bcm590xx_reg { -- 1.7.9.5
| |