lkml.org 
[lkml]   [2014]   [Mar]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] Documentation: dt: Reduce fragmentation of <..> placeholders
Date
Placeholders <..> are sometimes used in the devicetree documentation
to define family-wide compatible strings (like fsl,<chip>-ipu where
chip can be any Freescale SoC).

These placeholders are loosly defined. This lead to some
fragmentation. Looking at the current placeholders, we have:

3 <board>
32 <chip>
1 <chip name>
1 <mcu-chip>
1 <processor>
30 <soc>
1 <SOC>
1 <soc-family>

This patch consolidates this to:

3 <board>
33 <chip>
1 <mcu-chip>
1 <processor>
32 <soc>

Reported-by: Joe Perches <joe@perches.com>
Signed-off-by: Florian Vaussard <florian.vaussard@epfl.ch>
---
Documentation/devicetree/bindings/arm/samsung/sysreg.txt | 2 +-
Documentation/devicetree/bindings/pinctrl/pinctrl-st.txt | 2 +-
Documentation/devicetree/bindings/watchdog/sunxi-wdt.txt | 2 +-
3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/arm/samsung/sysreg.txt b/Documentation/devicetree/bindings/arm/samsung/sysreg.txt
index 0ab3251..b945b23 100644
--- a/Documentation/devicetree/bindings/arm/samsung/sysreg.txt
+++ b/Documentation/devicetree/bindings/arm/samsung/sysreg.txt
@@ -1,7 +1,7 @@
SAMSUNG S5P/Exynos SoC series System Registers (SYSREG)

Properties:
- - compatible : should contain "samsung,<chip name>-sysreg", "syscon";
+ - compatible : should contain "samsung,<chip>-sysreg", "syscon";
For Exynos4 SoC series it should be "samsung,exynos4-sysreg", "syscon";
- reg : offset and length of the register set.

diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-st.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-st.txt
index 05bf82a..393a53a 100644
--- a/Documentation/devicetree/bindings/pinctrl/pinctrl-st.txt
+++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-st.txt
@@ -12,7 +12,7 @@ ST pinctrl driver controls PIO multiplexing block and also interacts with
gpio driver to configure a pin.

Required properties: (PIO multiplexing block)
-- compatible : should be "st,<SOC>-<pio-block>-pinctrl"
+- compatible : should be "st,<soc>-<pio-block>-pinctrl"
like st,stih415-sbc-pinctrl, st,stih415-front-pinctrl and so on.
- gpio-controller : Indicates this device is a GPIO controller
- #gpio-cells : Should be one. The first cell is the pin number.
diff --git a/Documentation/devicetree/bindings/watchdog/sunxi-wdt.txt b/Documentation/devicetree/bindings/watchdog/sunxi-wdt.txt
index e39cb26..a7bee35 100644
--- a/Documentation/devicetree/bindings/watchdog/sunxi-wdt.txt
+++ b/Documentation/devicetree/bindings/watchdog/sunxi-wdt.txt
@@ -2,7 +2,7 @@ Allwinner SoCs Watchdog timer

Required properties:

-- compatible : should be "allwinner,<soc-family>-wdt", the currently supported
+- compatible : should be "allwinner,<soc>-wdt", the currently supported
SoC families being sun4i and sun6i
- reg : Specifies base physical address and size of the registers.

--
1.8.5.3


\
 
 \ /
  Last update: 2014-03-07 14:21    [W:0.063 / U:0.484 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site