lkml.org 
[lkml]   [2014]   [Nov]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] mmc: atmel-mci: adopt pinctrl support
Date
Amend the atmel mci pin controller to optionally take a pin control
handle and set the state of the pins to:
- "default" on boot, resume and before performing an transfer.
- "sleep" on suspend().

This should make it possible to optimize energy usage for the pins
both for the suspend/resume cycle.

Signed-off-by: Wenyou Yang <wenyou.yang@atmel.com>
---
Hi Ulf,

Thanks a lot.

According to your advice, remove pinctrl_pm_select_default_state(&pdev->dev) from the _probe function.

Best Regards,
Wenyou Yang

drivers/mmc/host/atmel-mci.c | 5 +++++
1 file changed, 5 insertions(+)

diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c
index 4df1599..a7b59ba 100644
--- a/drivers/mmc/host/atmel-mci.c
+++ b/drivers/mmc/host/atmel-mci.c
@@ -39,6 +39,7 @@
#include <linux/atmel_pdc.h>
#include <linux/pm.h>
#include <linux/pm_runtime.h>
+#include <linux/pinctrl/consumer.h>

#include <asm/cacheflush.h>
#include <asm/io.h>
@@ -2568,6 +2569,8 @@ static int atmci_runtime_suspend(struct device *dev)

clk_disable_unprepare(host->mck);

+ pinctrl_pm_select_sleep_state(dev);
+
return 0;
}

@@ -2575,6 +2578,8 @@ static int atmci_runtime_resume(struct device *dev)
{
struct atmel_mci *host = dev_get_drvdata(dev);

+ pinctrl_pm_select_default_state(dev);
+
return clk_prepare_enable(host->mck);
}
#endif
--
1.7.9.5


\
 
 \ /
  Last update: 2014-11-07 02:21    [W:0.061 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site