Messages in this thread | | | From | Roman Byshko <> | Subject | [PATCH v2 0/5] ARM: sunxi: Add support for USB OTG PHY | Date | Mon, 10 Nov 2014 19:55:05 +0100 |
| |
Hi,
There is already support for two USB phys, which are used for USB host controllers on Allwinner SoC aka sunxi.
This patch series add support for the USB OTG phy (aka phy0).
The code has been tested on Allwinner A20 aka sun7i (Cubietruck).
Best regards, Roman Byshko
Changes since v1: * Improved comment about 45 Ohm resistor calibration * Added Signed-off-by to all patches
Roman Byshko (5): phy: sun4i: add support for USB phy0 ARM: dtsi: sunxi: add common VBUS regulator ARM: sun7i: dtsi: add support for usbphy0 ARM: dts: sun7i: Cubietruck: override regulator pin ARM: dts: sun7i: Cubietruck: add power supply regulator for USB OTG VBUS
arch/arm/boot/dts/sun7i-a20-cubietruck.dts | 14 ++++++++++++++ arch/arm/boot/dts/sun7i-a20.dtsi | 4 ++-- arch/arm/boot/dts/sunxi-common-regulators.dtsi | 19 +++++++++++++++++++ drivers/phy/phy-sun4i-usb.c | 9 ++++++--- 4 files changed, 41 insertions(+), 5 deletions(-)
-- 2.1.2
| |