lkml.org 
[lkml]   [2013]   [Jul]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RFC][PATCH 3/8] ACPI / hotplug / PCI: Always return success after adding a function
Date
From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>

When a new ACPIPHP function is added by register_slot() and the
notify handler cannot be installed for it, register_slot() returns an
error status without cleaning up, which causes the entire namespace
walk in acpiphp_enumerate_slots() to be aborted, although it still
may be possible to successfully install the function notify handler
for other device objects under the given brigde.

To address this issue make register_slot() return success after
a new function has been added, even if the addition of the notify
handler for it has failed.

Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
---
drivers/pci/hotplug/acpiphp_glue.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)

Index: linux-pm/drivers/pci/hotplug/acpiphp_glue.c
===================================================================
--- linux-pm.orig/drivers/pci/hotplug/acpiphp_glue.c
+++ linux-pm/drivers/pci/hotplug/acpiphp_glue.c
@@ -335,10 +335,9 @@ register_slot(acpi_handle handle, u32 lv

if (ACPI_FAILURE(status))
err("failed to register interrupt notify handler\n");
- } else
- status = AE_OK;
+ }

- return status;
+ return AE_OK;

err_exit:
bridge->nr_slots--;


\
 
 \ /
  Last update: 2013-07-10 23:23    [W:0.836 / U:1.136 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site