Messages in this thread | | | Date | Mon, 20 May 2013 23:38:00 +0200 | From | Sebastian Hesselbarth <> | Subject | Re: [PATCH v3 6/7] ARM: kirkwood: add gigabit ethernet and mvmdio device tree nodes |
| |
On 05/20/2013 11:27 PM, Simon Baatz wrote: > Hi Sebastian, > > On Mon, May 06, 2013 at 05:33:39PM +0200, Sebastian Hesselbarth wrote: >> This patch adds mv643xx_eth and mvmdio device tree nodes for DT enabled >> Kirkwood boards. Phy nodes are also added with reg property set on a >> per-board basis. > ... >> diff --git a/arch/arm/boot/dts/kirkwood.dtsi b/arch/arm/boot/dts/kirkwood.dtsi >> index fada7e6..c01a273 100644 >> --- a/arch/arm/boot/dts/kirkwood.dtsi >> +++ b/arch/arm/boot/dts/kirkwood.dtsi >> @@ -202,5 +202,57 @@ >> clocks =<&gate_clk 4>; >> status = "disabled"; >> }; >> + >> + mdio: mdio-bus@72004 { >> + compatible = "marvell,orion-mdio"; >> + reg =<0x72004 0x84>; >> + interrupts =<11>; > > Shouldn't this be 46?
Yes, mdio is using GbE0Err interrupt and that is 14 on IRQ HIGH CAUSE. I was misled by 11 on IRQ LOW CAUSE.
Sebastian
| |