lkml.org 
[lkml]   [2013]   [Nov]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 1/1] Documentation/mfd: Fix typos in s2mps11.txt
From
On 8 November 2013 16:50, Sachin Kamat <sachin.kamat@linaro.org> wrote:
> On 8 November 2013 15:58, Lee Jones <lee.jones@linaro.org> wrote:
>> As this is only a trivial patch, I'll take it out the hands of the
>> already overloaded DT maintainers.
>>
>>> Fixed trivial typos to improve readability.
>>>
>>> Signed-off-by: Sachin Kamat <sachin.kamat@linaro.org>
>>> ---
>>> Documentation/devicetree/bindings/mfd/s2mps11.txt | 9 +++++----
>>> 1 file changed, 5 insertions(+), 4 deletions(-)
>>>
>>> diff --git a/Documentation/devicetree/bindings/mfd/s2mps11.txt b/Documentation/devicetree/bindings/mfd/s2mps11.txt
>>> index c9332c6..0ff4e65 100644
>>> --- a/Documentation/devicetree/bindings/mfd/s2mps11.txt
>>> +++ b/Documentation/devicetree/bindings/mfd/s2mps11.txt
>>> @@ -1,10 +1,10 @@
>>>
>>> * Samsung S2MPS11 Voltage and Current Regulator
>>>
>>> -The Samsung S2MP211 is a multi-function device which includes voltage and
>>> +The Samsung S2MPS11 is a multi-function device which includes voltage and
>>
>> Nice catch eagle-eye!
>
> :)
>
>>
>>> current regulators, RTC, charger controller and other sub-blocks. It is
>>> -interfaced to the host controller using a I2C interface. Each sub-block is
>>> -addressed by the host system using different I2C slave address.
>>> +interfaced to the host controller using an I2C interface. Each sub-block is
>>> +addressed by the host system using different I2C slave addresses.
>>>
>>> Required properties:
>>> - compatible: Should be "samsung,s2mps11-pmic".
>>> @@ -43,7 +43,8 @@ sub-node should be of the format as listed below.
>>>
>>> BUCK[2/3/4/6] supports disabling ramp delay on hardware, so explictly
>>> regulator-ramp-delay = <0> can be used for them to disable ramp delay.
>>> - In absence of regulator-ramp-delay property, default ramp delay will be used.
>>> + In the absence of regulator-ramp-delay property, default ramp delay will
>>> + be used.
>>
>> So if we're being pertinacity here, your correction isn't much better.
>>
>> s/of regulator-ramp-delay property,/of {the,an} regulator-ramp-delay property, the
>
> I like this one :)
>>
>> or
>>
>> s/of regulator-ramp-delay property,/of regulator-ramp-delay, the
>

Resent this patch with the above suggested changes and some more
updates and hence
with a modified subject line (Documentation/mfd: Update s2mps11.txt).

--
With warm regards,
Sachin


\
 
 \ /
  Last update: 2013-11-08 13:01    [W:0.065 / U:0.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site