lkml.org 
[lkml]   [2012]   [Jun]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH 14/22 v4] Input: atmel_mxt_ts - don't re-read matrix after applying pdata
On Mon, Jun 18, 2012 at 11:03 PM, Nick Dyer <nick.dyer@itdev.co.uk> wrote:
>
> Daniel Kurtz wrote:
> > The matrix x/y size in the Info ID Block represents the number of x/y
> > trace lines on the device.  There is no need to re-read them after
> > applying pdata config, since pdata only configures the object table
> > etnries.  The matrix size read from the ID can only be updated by a
> > firmware update.
>
> This isn't correct. For example, mXT224 can be configured as 16x14, 17x13,
> 18x12, etc. This only takes effect when the chip is reset, which is why it
> is necessary to re-read them after applying the config.

Ah, so is that what T46.1 (Mode) does? I hadn't played with that yet.
Ok, I'll move this patch into the next series which cleans up all of
the configuration stuff.

-Dan

>
>
> cheers
>
> --
> Nick Dyer
> Software Engineer, ITDev Ltd
> Hardware and Software Development Consultancy
> Website: http://www.itdev.co.uk
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2012-06-18 18:21    [W:0.267 / U:0.080 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site