lkml.org 
[lkml]   [2012]   [Jun]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 1/2] regulator: core.c Pass voltage to notifier when setting voltage
Date
V2
--

Incorporate performance suggestions made by Mark Brown
Use linux-next as base code rather than mmc-next

The voltage being set should be passed to the handler requesting
the callback. Currently this is not done.

The callback cannot call regulator_get_voltage() to get the
information since the mutex is held by the regulator and
deadlock occurs.

Without this change the receiver of the notify cannot now what
action to take. This is used, for example, to set PAD voltages
when doing SD vccq voltage changes.

Signed-off-by: Philip Rakity <prakity@marvell.com>
---
drivers/regulator/core.c | 6 +++---
1 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/regulator/core.c b/drivers/regulator/core.c
index 63507a5..5b04916 100644
--- a/drivers/regulator/core.c
+++ b/drivers/regulator/core.c
@@ -2153,7 +2153,7 @@ static int _regulator_do_set_voltage(struct regulator_dev *rdev,
if (rdev->desc->ops->list_voltage)
best_val = rdev->desc->ops->list_voltage(rdev, selector);
else
- best_val = -1;
+ best_val = _regulator_get_voltage(rdev);

/* Call set_voltage_time_sel if successfully obtained old_selector */
if (_regulator_is_enabled(rdev) && ret == 0 && old_selector >= 0 &&
@@ -2176,9 +2176,9 @@ static int _regulator_do_set_voltage(struct regulator_dev *rdev,
udelay(delay);
}

- if (ret == 0)
+ if (ret == 0 && best_val >= 0)
_notifier_call_chain(rdev, REGULATOR_EVENT_VOLTAGE_CHANGE,
- NULL);
+ (void *)best_val);

trace_regulator_set_voltage_complete(rdev_get_name(rdev), best_val);

--
1.7.0.4


\
 
 \ /
  Last update: 2012-06-15 00:41    [W:0.567 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site