lkml.org 
[lkml]   [2012]   [Nov]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/5] Input: bu21013_ts - Move GPIO init and exit functions into the driver
On Wed, 21 Nov 2012, Dmitry Torokhov wrote:

> Hi Lee,
>
> On Wed, Nov 14, 2012 at 01:47:14PM +0000, Lee Jones wrote:
> > @@ -272,6 +276,60 @@ static irqreturn_t bu21013_gpio_irq(int irq, void *device_data)
> > }
> >
> > /**
> > + * bu21013_gpio_board_init() - configures the touch panel
> > + * @reset_pin: reset pin number
> > + *
> > + * This function is used to configure the voltage and
> > + * reset the touch panel controller.
> > + */
> > +static int bu21013_gpio_board_init(int reset_pin)
> > +{
> > + int retval = 0;
> > +
> > + bu21013_devices++;
> > + if (bu21013_devices == 1) {
>
> This does not make sense. If gpio is per-device now then we should
> simply set it up and not count devices.

No problem. I'll fixup.

--
Lee Jones
Linaro ST-Ericsson Landing Team Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2012-11-24 12:01    [W:0.318 / U:0.044 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site