lkml.org 
[lkml]   [2011]   [Dec]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2] i2c: tegra: Add delay before reset the controller
Date
From: Alok Chauhan <alokc@nvidia.com>

In NACK error condition, I2C controller violates
clock-to-data setup time before stop. In Software,
because of this reset of controller is happening
before I2C controller could complete STOP condition.

Added delay of 2 clock period before reset the
controller in case of NACK error.

Signed-off-by: Alok Chauhan <alokc@nvidia.com>
---
Instead of setting constant value for delay as was in previous patch, now in
the current modification delay will be calculated based on clock frequency of the bus.
drivers/i2c/busses/i2c-tegra.c | 8 ++++++++
1 files changed, 8 insertions(+), 0 deletions(-)

diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index 6381604..62e197c 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -517,6 +517,14 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
if (likely(i2c_dev->msg_err == I2C_ERR_NONE))
return 0;

+ /*
+ * In NACK error condition resetting of I2C controller happens
+ * before STOP condition is properly completed by I2C controller,
+ * so wait for 2 clock cycle to complete STOP condition.
+ */
+ if (i2c_dev->msg_err == I2C_ERR_NO_ACK)
+ udelay(DIV_ROUND_UP(2 * 1000000, i2c_dev->bus_clk_rate));
+
tegra_i2c_init(i2c_dev);
if (i2c_dev->msg_err == I2C_ERR_NO_ACK) {
if (msg->flags & I2C_M_IGNORE_NAK)
--
1.7.4.1


\
 
 \ /
  Last update: 2011-12-26 12:17    [W:0.106 / U:0.932 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site