Messages in this thread Patch in this message | | | From | Nitin Gupta <> | Subject | [PATCH 4/4] compcache: documentation | Date | Mon, 24 Aug 2009 10:08:02 +0530 |
| |
Short guide on how to setup and use ramzswap.
Signed-off-by: Nitin Gupta <ngupta@vflare.org> ---
Documentation/blockdev/00-INDEX | 2 + Documentation/blockdev/ramzswap.txt | 52 +++++++++++++++++++++++++++++++++++ 2 files changed, 54 insertions(+), 0 deletions(-)
diff --git a/Documentation/blockdev/00-INDEX b/Documentation/blockdev/00-INDEX index c08df56..c1cb074 100644 --- a/Documentation/blockdev/00-INDEX +++ b/Documentation/blockdev/00-INDEX @@ -16,3 +16,5 @@ paride.txt - information about the parallel port IDE subsystem. ramdisk.txt - short guide on how to set up and use the RAM disk. +ramzswap.txt + - short guide on how to setup compressed in-memory swap device. diff --git a/Documentation/blockdev/ramzswap.txt b/Documentation/blockdev/ramzswap.txt new file mode 100644 index 0000000..463dd2d --- /dev/null +++ b/Documentation/blockdev/ramzswap.txt @@ -0,0 +1,52 @@ +ramzswap: Compressed RAM based swap device +------------------------------------------- + +Project home: http://compcache.googlecode.com/ + +* Introduction + +It creates RAM based block devices which can be used (only) as swap disks. +Pages swapped to these devices are compressed and stored in memory itself. +See project home for use cases, performance numbers and a lot more. + +It consists of three modules: + - xvmalloc.ko: memory allocator + - ramzswap.ko: virtual block device driver + - rzscontrol userspace utility: to control individual ramzswap devices + +* Usage + +Following shows a typical sequence of steps for using ramzswap. + +1) Load Modules: + modprobe ramzswap NUM_DEVICES=4 + This creates 4 (uninitialized) devices: /dev/ramzswap{0,1,2,3} + (NUM_DEVICES parameter is optional. Default: 1) + +2) Initialize: + Use rzscontrol utility to configure and initialize individual + ramzswap devices. Example: + rzscontrol /dev/ramzswap2 --init # uses default value of disksize_kb + + *See rzscontrol manpage for more details and examples* + +3) Activate: + swapon /dev/ramzswap2 # or any other initialized ramzswap device + +4) Stats: + rzscontrol /dev/ramzswap2 --stats + +5) Deactivate: + swapoff /dev/ramzswap2 + +6) Reset: + rzscontrol /dev/ramzswap2 --reset + (This frees all the memory allocated for this device). + + +Please report any problems at: + - Mailing list: linux-mm-cc at laptop dot org + - Issue tracker: http://code.google.com/p/compcache/issues/list + +Nitin Gupta +ngupta@vflare.org
| |