lkml.org 
[lkml]   [2008]   [Oct]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [2.6.28-rc2]: iwl4965 doesn't connect / cfg80211 failure
From
Date
On Mon, 2008-10-27 at 18:02 -0700, Mirco Tischler wrote:
> Hi
>
> I have problems connecting to wlan with my iwl4965 chip and 2.6.28-rc2 (didn't
> test -rc1). Networkmanager just times out every time.
> Only after playing around with rmmod/modprobe and killswitch I am sometimes
> able to connect. But I cannot reproduce this reliably yet.
>
> This is what I get in dmesg (from modprobe iwlagn to connection failure):
>
> [ 1881.884690] iwlagn: Intel(R) Wireless WiFi Link AGN driver for
> Linux,1.3.27kds
> [ 1881.884692] iwlagn: Copyright(c) 2003-2008 Intel Corporation
> [ 1881.884809] iwlagn 0000:06:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
> [ 1881.884836] iwlagn 0000:06:00.0: setting latency timer to 64
> [ 1881.884952] iwlagn: Detected Intel Wireless WiFi Link 4965AGN REV=0x4
> [ 1881.935149] iwlagn: Tunable channels: 13 802.11bg, 19 802.11a channels
> [ 1881.936327] phy4: Selected rate control algorithm 'iwl-agn-rs'
> [ 1885.965591] iwlagn 0000:06:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18
> [ 1885.965874] iwlagn 0000:06:00.0: irq 41 for MSI/MSI-X
> [ 1885.965974] iwlagn 0000:06:00.0: firmware: requesting iwlwifi-4965-2.ucode
> [ 1886.181600] Registered led device: iwl-phy4:radio
> [ 1886.181618] Registered led device: iwl-phy4:assoc
> [ 1886.181635] Registered led device: iwl-phy4:RX
> [ 1886.181654] Registered led device: iwl-phy4:TX
> [ 1886.213631] ADDRCONF(NETDEV_UP): wlan0: link is not ready
> [ 1887.572768] iwlagn: TX Power requested while scanning!

Looks good so far. But I failed to see what are you trying to connect?
Can you try "iwconfig wlan0 channnel <> essid <>"?

> What might be related is this early on boot:
>
> [ 0.163009] cfg80211: Calling CRDA to update world regulatory domain
> [ 0.163012] cfg80211: Failed calling CRDA
> [ 0.163024] cfg80211: calling CRDA failed - unable to update world
> regulatory domain, using static definition

Does your AP work on A band?

Thanks,
-yi



\
 
 \ /
  Last update: 2008-10-28 02:37    [W:0.069 / U:0.496 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site