Messages in this thread | | | Date | Thu, 15 Feb 2007 09:48:49 +0100 | From | "Patrick Ale" <> | Subject | [LIBATA] drives not detected |
| |
Good morning all,
Yesterday I replaced a Sil680 PCI add-on card for a Promise 2027x PCI add-on card.
Now, when I boot up, I miss two drives, exactly the two connected to this promise card. I have another onboard Promise controller which works just fine, so the driver gets loaded properly, and since i see all my other disks but these two I think we can rule out a misconfiguration of the kernel config this time ;-)
This is a snippet from my dmesg
pata_pdc2027x 0000:00:0b.0: version 0.74-ac5 ACPI: PCI Interrupt 0000:00:0b.0[A] -> GSI 19 (level, low) -> IRQ 20 pata_pdc2027x 0000:00:0b.0: PLL input clock 16799 kHz ata7: PATA max UDMA/133 cmd 0xf98a17c0 ctl 0xf98a1fda bmdma 0xf98a1000 irq 20 ata8: PATA max UDMA/133 cmd 0xf98a15c0 ctl 0xf98a1dda bmdma 0xf98a1008 irq 20 scsi7 : pata_pdc2027x scsi8 : pata_pdc2027x ATA: abnormal status 0x8 on port 0xf98a15df
As you can see, scsi8 gives an abnormal status, which as we got pointed out this week is just a cosmetic error for "No drive attached/detected" and it's very right in that finding.
But what about scsi7? no warning/error about no disks being attached nor a disk detection.
To state the obvious: I see the disks being detected by the Promise BIOS when I boot the system,Primaiy master and Primaiy slave.
Here is the lspci -vvv regarding the controller
00:0b.0 Mass storage controller: Promise Technology, Inc. 20269 (rev 02) (prog-if 85) Subsystem: Promise Technology, Inc. Ultra133TX2 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66MHz+ UDF- FastB2B- ParErr- DEVSEL=slow >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (1000ns min, 4500ns max), Cache Line Size: 32 bytes Interrupt: pin A routed to IRQ 20 Region 0: I/O ports at 9400 [size=8] Region 1: I/O ports at 9800 [size=4] Region 2: I/O ports at 9c00 [size=8] Region 3: I/O ports at a000 [size=4] Region 4: I/O ports at a400 [size=16] Region 5: Memory at eb000000 (32-bit, non-prefetchable) [size=16K] [virtual] Expansion ROM at ea100000 [disabled] [size=16K] Capabilities: [60] Power Management version 1 Flags: PMEClk- DSI+ D1+ D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-) Status: D0 PME-Enable- DSel=0 DScale=0 PME-
Take care all!
Patrick - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |