Messages in this thread | | | Date | Thu, 7 Sep 2006 20:06:07 -0700 | From | "Miles Lane" <> | Subject | 2.6.18-rc5-mm1 + all hotfixes + nodemgr patches -- INFO: trying to register non-static key (the code is fine but needs lockdep annotation). |
| |
ieee1394: Initialized config rom entry `ip1394' SCSI subsystem initialized ieee1394: sbp2: Driver forced to serialize I/O (serialize_io=1) ieee1394: sbp2: Try serialize_io=0 for better performance ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[22] MMIO=[e0207000-e02077ff] Max Packet=[2048] IR/IT contexts=[4/8] ohci1394: fw-host0: Running dma failed because Node ID is not valid ohci1394: fw-host0: AT dma reset ctx=0, aborting transmission ieee1394: Current remote IRM is not 1394a-2000 compliant, resetting... PM: Adding info for ieee1394:00c09f00004fec18 ieee1394: Host added: ID:BUS[0-00:1023] GUID[00c09f00004fec18] PM: Adding info for ieee1394:00c09f00004fec18-0 ieee1394: Current remote IRM is not 1394a-2000 compliant, resetting... PM: Adding info for ieee1394:0080880002103eae ieee1394: Node added: ID:BUS[1-00:1023] GUID[0080880002103eae] PM: Adding info for ieee1394:0090a950000b2255 ieee1394: Node added: ID:BUS[1-01:1023] GUID[0090a950000b2255] PM: Adding info for ieee1394:0090a94000007475 ieee1394: Host added: ID:BUS[1-02:1023] GUID[0090a94000007475] PM: Adding info for ieee1394:0080880002103eae-0 PM: Adding info for ieee1394:0090a950000b2255-0 scsi0 : SBP-2 IEEE-1394 PM: Adding info for No Bus:host0 ieee1394: raw1394: /dev/raw1394 device initialized ieee1394: sbp2: Logged into SBP-2 device ieee1394: Node 1-01:1023: Max speed [S400] - Max payload [1024] PM: Adding info for No Bus:target0:0:0 ieee1394: sbp2: aborting sbp2 command scsi 0:0:0:0: command: cdb[0]=0x12: 12 00 00 00 24 00 INFO: trying to register non-static key. the code is fine but needs lockdep annotation. turning off the locking correctness validator. [<c1003d3a>] dump_trace+0x64/0x1a2 [<c1003e8a>] show_trace_log_lvl+0x12/0x25 [<c1004164>] show_trace+0xd/0x10 [<c100417e>] dump_stack+0x17/0x19 [<c1038b9c>] __lock_acquire+0x11d/0xa07 [<c1039763>] lock_acquire+0x5e/0x7f [<c11e53b2>] _spin_lock_irq+0x1f/0x2e [<c11e3967>] wait_for_completion_timeout+0x2c/0xb9 [<f902f441>] scsi_send_eh_cmnd+0x20a/0x318 [scsi_mod] [<f902f573>] scsi_eh_tur+0x24/0x4c [scsi_mod] [<f902fc29>] scsi_error_handler+0x1b2/0x599 [scsi_mod] [<c1032b1d>] kthread+0xc4/0xf3 [<c10039d3>] kernel_thread_helper+0x7/0x10 DWARF2 unwinder stuck at kernel_thread_helper+0x7/0x10
Leftover inexact backtrace:
[<c1003e8a>] show_trace_log_lvl+0x12/0x25 [<c1004164>] show_trace+0xd/0x10 [<c100417e>] dump_stack+0x17/0x19 [<c1038b9c>] __lock_acquire+0x11d/0xa07 [<c1039763>] lock_acquire+0x5e/0x7f [<c11e53b2>] _spin_lock_irq+0x1f/0x2e [<c11e3967>] wait_for_completion_timeout+0x2c/0xb9 [<f902f441>] scsi_send_eh_cmnd+0x20a/0x318 [scsi_mod] [<f902f573>] scsi_eh_tur+0x24/0x4c [scsi_mod] [<f902fc29>] scsi_error_handler+0x1b2/0x599 [scsi_mod] [<c1032b1d>] kthread+0xc4/0xf3 [<c10039d3>] kernel_thread_helper+0x7/0x10 ======================= scsi 0:0:0:0: Direct-Access-RBC WDC FireWire/USB2.0 4.17 PQ: 0 ANSI: 4 PM: Adding info for scsi:0:0:0:0 PM: Adding info for ieee1394:0090a94000007475-0 SCSI device sda: 390721968 512-byte hdwr sectors (200050 MB) sda: Write Protect is off sda: Mode Sense: 0c 00 00 00 PM: Adding info for No Bus:vcs7 PM: Adding info for No Bus:vcsa7 PM: Removing info for No Bus:vcs7 PM: Removing info for No Bus:vcsa7 apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16ac) apm: overridden by ACPI. ieee1394: sbp2: aborting sbp2 command sd 0:0:0:0: command: cdb[0]=0x1a: 1a 08 06 00 04 00 SCSI device sda: drive cache: write back SCSI device sda: 390721968 512-byte hdwr sectors (200050 MB) sda: Write Protect is off sda: Mode Sense: 0c 00 00 00 ieee1394: sbp2: aborting sbp2 command sd 0:0:0:0: command: cdb[0]=0x1a: 1a 08 06 00 04 00 ieee1394: sbp2: hpsb_node_write failed. ieee1394: sbp2: aborting sbp2 command sd 0:0:0:0: command: cdb[0]=0x0: 00 00 00 00 00 00 ieee1394: sbp2: reset requested ieee1394: sbp2: Generating sbp2 fetch agent reset ieee1394: sbp2: aborting sbp2 command sd 0:0:0:0: command: cdb[0]=0x0: 00 00 00 00 00 00 sd 0:0:0:0: scsi: Device offlined - not ready after error recovery sda: asking for cache data failed sda: assuming drive cache: write through sda:<3>sd 0:0:0:0: rejecting I/O to offline device Buffer I/O error on device sda, logical block 0 sd 0:0:0:0: rejecting I/O to offline device Buffer I/O error on device sda, logical block 0 sd 0:0:0:0: rejecting I/O to offline device Buffer I/O error on device sda, logical block 0 ldm_validate_partition_table(): Disk read failed. sd 0:0:0:0: rejecting I/O to offline device Buffer I/O error on device sda, logical block 0 unable to read partition table sd 0:0:0:0: Attached scsi disk sda sd 0:0:0:0: Attached scsi generic sg0 type 14 - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |