Messages in this thread | | | From | (Danny ter Haar) | Subject | No luck getting 2.6.x kernel to work with ACPI on compaq laptop | Date | Wed, 21 Apr 2004 05:51:30 +0000 (UTC) |
| |
My Compaq presario 700EA locks up dead during boot with ACPI enabled. With bootoption acpi=off (or not compiled into the kernel) the machine works just fine.
I put on acpi debug and typed over by hand (laptop's dont have serial ports these days anymore) :
ACPI: Subsystem revision 20040326 tbxface-0017[03] acpi_load_tables: ACPI tables succesfully acquired Parsing all Control Methods: [......] Table [DSDT] (id F005) - 433 Objects with 44 Devices 109 Methods 15 Regions Parsing all Control Methods: Table [SSDT] (id f003) - 3 objects with 0 Devices 0 Methods 0 Regions ACPI: IRQ10 SCI: Edge set to level trigger
After this the machine is dead in the water. No magic sysrq or anything.
Any ideas how to solve this issue ? I googled around a bit but found nothing usefull. I upgraded bios to latest available from compaq, with no different results.
Help/suggestions appreciated.
Danny -- /"\ | Dying is to be avoided because \ / ASCII RIBBON CAMPAIGN | it can ruin your whole career X against HTML MAIL | / \ and POSTINGS | - Bob Hope
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |