Messages in this thread | | | From | "Mile Davidovic" <> | Subject | ITERaid and atkbd | Date | Tue, 16 Nov 2004 15:23:30 +0100 |
| |
Hi folks
I have trouble with IT8212F raid controller (on Gigabyte boards also known as GigaRaid) on FedoraCore 3. There was some problem with building modules but after some fixing Makefile I succeeded to build module.
After loading module dmesg shows: Found Controller: IT8212 UDMA/ATA133 RAID Controller FindDevices: device 0 is IDE FindDevices: device 1 is IDE Channel[0] BM-DMA at 0xA400-0xA407 Channel[1] BM-DMA at 0xA408-0xA40F scsi2 : ITE RAIDExpress133 Vendor: ITE Model: IT8212F Rev: 1.3 Type: Direct-Access ANSI SCSI revision: 00 SCSI device sdb: 488397166 512-byte hdwr sectors (250059 MB) sdb: asking for cache data failed sdb: assuming drive cache: write through sdb: sdb1 Attached scsi disk sdb at scsi2, channel 0, id 0, lun 0 Vendor: ITE Model: IT8212F Rev: 1.3 Type: Direct-Access ANSI SCSI revision: 00 SCSI device sdc: 488397166 512-byte hdwr sectors (250059 MB) sdc: asking for cache data failed sdc: assuming drive cache: write through sdc:<4>atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known. atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known. sdc1 Attached scsi disk sdc at scsi2, channel 0, id 1, lun 0
[root@beowulf scsi]# mount /dev/sdb1 /mnt/ atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known. ... atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known. kjournald starting. Commit interval 5 seconds atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known. EXT3 FS on sdb1, internal journal EXT3-fs: mounted filesystem with ordered data mode. atkbd.c: Unknown key pressed (translated set 2, code 0x0 on isa0060/serio0). atkbd.c: Use 'setkeycodes 00 <keycode>' to make it known.
I found a lot of messages with this subject but I didn't found any final answer. I also tried to use iteraid driver from mm tree but situation is same.
Thanks in a advice Best regards Mile
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |