Messages in this thread | | | Date | Wed, 17 Sep 2003 14:42:13 +0300 (EEST) | From | Meelis Roos <> | Subject | Qlogic ISP & sparc64 & 2.4 |
| |
I tried to load qlogicisp module on my sparc64 (Ultra 5). modprobe failed, dmesg shows
qlogicisp : new isp1020 revision ID (2) qlogicisp : ram checksum failure
Is this a problem with unsupported card or a problem with qlogicisp driver on sparc64?
From lspci -vvv:
02:01.0 SCSI storage controller: QLogic Corp. ISP1020 Fast-wide SCSI (rev 02) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, cache line size 10 Interrupt: pin A routed to IRQ 6672128 Region 0: I/O ports at 2000500 [size=256] Region 1: Memory at 000001ff00010000 (32-bit, non-prefetchable) [size=4K] Expansion ROM at <unassigned> [size=64K]
-- Meelis Roos (trying BusLogic FlashPoint next :)))
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |