lkml.org 
[lkml]   [2003]   [Jul]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
Subject[PATCH] Re: VIA PCI IRQ router bug fix
Aleksey Gorelov wrote:
> Hi.
>
> I found & fixed a problem with #PIRQD line setup for VIA PCI IRQ
> router. Kernel was not able to receive any interrupts from network card,
> which PCI slot IRQ pin A was routed to PIRQ line D of VIA PCI IRQ
> router. According to VIA specs, PIRQ D routing is out of standard
> 'nibble' scheme.
> I tested patch with 2.4.20 kernel, it can be applied to 2.4.22-pre2 as
> well.
> Thanks to my employer (Phoenix Technologies) who kindly allowed me to
> make this patch public.

Thanks much! Please continue to encourage your employer to contribute
to open source. Posting patches like this means that all Linux via
users have a more stable system to use.


> --- linux-2.4.20/arch/i386/kernel/pci-irq_old.c 2002-11-28 15:53:09.000000000 -0800
> +++ linux-2.4.20/arch/i386/kernel/pci-irq.c 2003-05-21 17:27:40.000000000 -0700
> @@ -198,12 +198,27 @@
> */
> static int pirq_via_get(struct pci_dev *router, struct pci_dev *dev, int pirq)
> {
> - return read_config_nybble(router, 0x55, pirq);
> + u8 x;
> +
> + if ( pirq == 4 ) {
> + pci_read_config_byte(router, 0x57, &x);
> + return (x >> 4);
> + } else {
> + return read_config_nybble(router, 0x55, pirq);
> + }
> }

If you don't mind, I would prefer the attached patch, which is a little
bit less verbose.

I will make sure this fix is merged into 2.4 and 2.5, if noone beats me
to it.

Jeff


===== arch/i386/pci/irq.c 1.25 vs edited =====
--- 1.25/arch/i386/pci/irq.c Thu Jun 19 17:58:11 2003
+++ edited/arch/i386/pci/irq.c Thu Jul 3 19:49:14 2003
@@ -196,15 +196,16 @@
/*
* The VIA pirq rules are nibble-based, like ALI,
* but without the ugly irq number munging.
+ * However, PIRQD is in the upper instead of lower 4 bits.
*/
static int pirq_via_get(struct pci_dev *router, struct pci_dev *dev, int pirq)
{
- return read_config_nybble(router, 0x55, pirq);
+ return read_config_nybble(router, 0x55, pirq == 4 ? 5 : pirq);
}

static int pirq_via_set(struct pci_dev *router, struct pci_dev *dev, int pirq, int irq)
{
- write_config_nybble(router, 0x55, pirq, irq);
+ write_config_nybble(router, 0x55, pirq == 4 ? 5 : pirq, irq);
return 1;
}
\
 
 \ /
  Last update: 2005-03-22 13:46    [W:0.038 / U:0.132 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site