Messages in this thread | | | Date | Fri, 10 Jan 2003 17:23:31 -0500 (EST) | From | Bill Davidsen <> | Subject | [BUG] 2.5.5x can't find my printer |
| |
The 2.5.5x kernels can't find my printer. 2.4 kernels work fine. dmesg attached, I'll send config if anyone cares.
Known problem, new problem, or just some config error? The modules load but don't find anything.
lsmod: Module Size Used by apm 15140 parport_pc 33320 parport 34496 -- bill davidsen <davidsen@tmr.com> Linux version 2.5.54 (root@oddball.prodigy.com) (gcc version 2.96 20000731 (Red Hat Linux 7.3 2.96-110)) #1 Wed Jan 8 19:20:44 EST 2003 Video mode to be used for restore is ffff BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000e7400 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 00000000040fdc00 (usable) BIOS-e820: 00000000040fdc00 - 00000000040ff800 (ACPI data) BIOS-e820: 00000000040ff800 - 00000000040ffc00 (ACPI NVS) BIOS-e820: 00000000040ffc00 - 0000000006000000 (usable) BIOS-e820: 00000000fffe7400 - 0000000100000000 (reserved) 96MB LOWMEM available. On node 0 totalpages: 24576 DMA zone: 4096 pages, LIFO batch:1 Normal zone: 20480 pages, LIFO batch:5 HighMem zone: 0 pages, LIFO batch:1 Building zonelist for node : 0 Kernel command line: BOOT_IMAGE=2.5.54-1 ro root=303 BOOT_FILE=/boot/vmlinuz-2.5.54 nmi_watchdog=1 Initializing CPU#0 Detected 348.402 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 688.12 BogoMIPS Memory: 93932k/98304k available (1660k kernel code, 3840k reserved, 605k data, 284k init, 0k highmem) Dentry cache hash table entries: 16384 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) Mount-cache hash table entries: 512 (order: 0, 4096 bytes) -> /dev -> /dev/console -> /root CPU: L1 I cache: 16K, L1 D cache: 16K CPU: L2 cache: 512K CPU: After generic, caps: 0183f9ff 00000000 00000000 00000000 CPU: Intel Pentium II (Deschutes) stepping 01 Enabling fast FPU save and restore... done. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket mtrr: v2.0 (20020519) device class 'cpu': registering device class cpu: adding driver system:cpu PCI: PCI BIOS revision 2.10 entry at 0xfd994, last bus=1 PCI: Using configuration type 1 device class cpu: adding device CPU 0 interfaces: adding device CPU 0 BIO: pool of 256 setup, 15Kb (60 bytes/bio) biovec pool[0]: 1 bvecs: 182 entries (12 bytes) biovec pool[1]: 4 bvecs: 182 entries (48 bytes) biovec pool[2]: 16 bvecs: 182 entries (192 bytes) biovec pool[3]: 64 bvecs: 91 entries (768 bytes) biovec pool[4]: 128 bvecs: 45 entries (1536 bytes) biovec pool[5]: 256 bvecs: 22 entries (3072 bytes) Linux Plug and Play Support v0.93 (c) Adam Belay pnp: the driver 'system' has been registered pnp: Enabling Plug and Play Card Services. PnPBIOS: Found PnP BIOS installation structure at 0xc00f6f70 PnPBIOS: PnP BIOS version 1.0, entry 0xf0000:0x9db3, dseg 0x400 pnp: pnp: match found with the PnP device '00:00' and the driver 'system' pnp: pnp: match found with the PnP device '00:01' and the driver 'system' pnp: 00:01: ioport range 0x370-0x371 has been reserved pnp: pnp: match found with the PnP device '00:02' and the driver 'system' pnp: pnp: match found with the PnP device '00:0b' and the driver 'system' pnp: 00:0b: ioport range 0x4d0-0x4d1 has been reserved pnp: 00:0b: ioport range 0x8000-0x803f has been reserved pnp: 00:0b: ioport range 0x7000-0x700f has been reserved pnp: pnp: match found with the PnP device '00:0c' and the driver 'system' PnPBIOS: 17 nodes reported by PnP BIOS; 17 recorded by driver block request queues: 128 requests per read queue 128 requests per write queue 8 requests per batch enter congestion at 31 exit congestion at 33 drivers/usb/core/usb.c: registered new driver usbfs drivers/usb/core/usb.c: registered new driver hub PCI: Probing PCI hardware PCI: Probing PCI hardware (bus 00) PCI: Address space collision on region 7 of bridge 00:07.3 [8000:803f] PCI: Address space collision on region 8 of bridge 00:07.3 [7000:701f] PCI: Using IRQ router PIIX [8086/7110] at 00:07.0 SLIP: version 0.8.4-NET3.019-NEWTTY (dynamic channels, max=256) (6 bit encapsulation enabled). CSLIP: code copyright 1989 Regents of the University of California. SLIP linefill/keepalive option. Enabling SEP on CPU 0 aio_setup: sizeof(struct page) = 40 Journalled Block Device driver loaded Installing knfsd (copyright (C) 1996 okir@monad.swb.de). Initializing Cryptographic API Limiting direct PCI/PCI transfers. isapnp: Scanning for PnP cards... isapnp: No Plug & Play device found Serial: 8250/16550 driver $Revision: 1.90 $ IRQ sharing disabled ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A pnp: the driver 'serial' has been registered pnp: pnp: match found with the PnP device '00:0e' and the driver 'serial' device class 'tty': registering pty: 256 Unix98 ptys configured Real Time Clock Driver v1.11 Software Watchdog Timer: 0.06, soft_margin: 60 sec, nowayout: 0 Linux agpgart interface v0.100 (c) Dave Jones agpgart: Detected Intel 440BX chipset agpgart: Maximum main memory to use for agp memory: 62M agpgart: AGP aperture is 64M @ 0xf8000000 Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize loop: loaded (max 8 devices) Intel(R) PRO/100 Network Driver - version 2.1.24-k2 Copyright (c) 2002 Intel Corporation
PCI: Found IRQ 9 for device 00:06.0 PCI: Sharing IRQ 9 with 00:07.2 e100: selftest OK. Freeing alive device c5f0a000, eth%d e100: eth0: Intel(R) 82558-based Integrated Ethernet with Wake on LAN* Mem:0xf6200000 IRQ:9 Speed:0 Mbps Dx:N/A
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx PIIX4: IDE controller at PCI slot 00:07.1 PIIX4: chipset revision 1 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1020-0x1027, BIOS settings: hda:DMA, hdb:pio ide1: BM-DMA at 0x1028-0x102f, BIOS settings: hdc:DMA, hdd:pio hda: Maxtor 90845D4, ATA DISK drive hdb: WDC AC31600H, ATA DISK drive hdb: Disabling (U)DMA for WDC AC31600H ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hdc: NEC CD-ROM DRIVE:28C, ATAPI CD/DVD-ROM drive ide1 at 0x170-0x177,0x376 on irq 15 hda: host protected area => 1 hda: 16514064 sectors (8455 MB) w/512KiB Cache, CHS=16383/16/63, UDMA(33) hda: hda1 hda2 hda3 hda4 < hda5 > hdb: task_no_data_intr: status=0x51 { DriveReady SeekComplete Error } hdb: task_no_data_intr: error=0x10 { SectorIdNotFound }, LBAsect=0, sector=0 hdb: 3173184 sectors (1625 MB) w/128KiB Cache, CHS=3148/16/63 hdb: hdb1 hdb2 hdb3 hdc: ATAPI 32X CD-ROM drive, 128kB Cache, UDMA(33) Uniform CD-ROM driver Revision: 3.12 end_request: I/O error, dev hdc, sector 0 device class 'input': registering register interface 'mouse' with class 'input' mice: PS/2 mouse device common for all mice input: PC Speaker input: ImPS/2 Logitech Wheel Mouse on isa0060/serio1 serio: i8042 AUX port at 0x60,0x64 irq 12 input: AT Set 2 keyboard on isa0060/serio0 serio: i8042 KBD port at 0x60,0x64 irq 1 NET4: Linux TCP/IP 1.0 for NET4.0 IP: routing cache hash table of 512 buckets, 4Kbytes TCP: Hash tables configured (established 8192 bind 8192) ip_conntrack version 2.1 (768 buckets, 6144 max) - 304 bytes per conntrack ip_tables: (C) 2000-2002 Netfilter core team NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. VFS: Mounted root (ext3 filesystem) readonly. Freeing unused kernel memory: 284k freed Adding 200804k swap on /dev/hda2. Priority:-1 extents:1 EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,3), internal journal kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,1), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,5), internal journal EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.16, 02 Dec 2001 on ide0(3,67), internal journal EXT3-fs: mounted filesystem with ordered data mode. end_request: I/O error, dev hdc, sector 0 end_request: I/O error, dev hdc, sector 0 hdc: DMA disabled pnp: the driver 'parport_pc' has been registered pnp: pnp: match found with the PnP device '00:12' and the driver 'parport_pc' pnp: the device '00:12' has been activated parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE] parport0: irq 7 detected parport0: cpp_mux: aa55f00f52ad51(80) parport0: cpp_daisy: aa5500ff(80) parport0: assign_addrs: aa5500ff(80) Module parport cannot be unloaded due to unsafe usage in include/linux/module.h:347 Module parport_pc cannot be unloaded due to unsafe usage in include/linux/module.h:347 parport0: cpp_mux: aa55f00f52ad51(80) parport0: cpp_daisy: aa5500ff(80) parport0: assign_addrs: aa5500ff(80) e100: eth0 NIC Link is Up 10 Mbps Half duplex warning: process `update' used the obsolete bdflush system call Fix your initscripts? warning: process `update' used the obsolete bdflush system call Fix your initscripts?
| |