Messages in this thread | | | Date | Wed, 30 Jan 2002 19:47:33 -0500 | From | Andres Salomon <> | Subject | tulip woes |
| |
w/ 2.4.18-pre7-ac1, I get the following:
Jan 30 07:43:47 pinky kernel: Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001) Jan 30 07:43:47 pinky kernel: PCI: Found IRQ 11 for device 00:08.0 Jan 30 07:43:47 pinky kernel: 00:08.0: PCI cache line size set incorrectly (32 bytes) by BIOS/FW, correcting to 64 Jan 30 07:43:47 pinky kernel: eth0: Lite-On PNIC-II rev 37 at 0xe0836000, 00:A0:CC:33:0D:FA, IRQ 11. Jan 30 07:43:47 pinky kernel: eth0: Autonegotiation failed, using 10baseT, link beat status 10cc. Jan 30 07:44:10 pinky kernel: NETDEV WATCHDOG: eth0: transmit timed out Jan 30 07:44:10 pinky kernel: eth0: PNIC2 transmit timed out, status e4260000, CSR6/7 e0402002 / effffbff CSR12 000000c8, resetting... Jan 30 07:44:18 pinky kernel: NETDEV WATCHDOG: eth0: transmit timed out Jan 30 07:44:18 pinky kernel: eth0: PNIC2 transmit timed out, status e4260000, CSR6/7 e0402002 / effffbff CSR12 000000c8, resetting...
The nic is connected to a 100mbit hub, hence the autonegotion defaulting to 10baseT makes it pretty useless. It works fine w/ 2.4.10-ac12's tulip driver. I also tried the tulip-1.1.8 driver from the tulip sourceforge page, as well as compiling 2.4.18-pre7-ac1's tulip driver w/out CONFIG_TULIP_MWI and CONFIG_TULIP_MMIO; they all had autonegotiation fail.
Output from lspci:
00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 03) Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR- Latency: 0 Region 0: Memory at d8000000 (32-bit, prefetchable) [size=64M] Capabilities: <available only to root>
00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] (prog-if 00 [Normal decode]) Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort+ >SERR- <PERR- Latency: 0 Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 I/O behind bridge: 0000c000-0000cfff Memory behind bridge: dc000000-ddffffff Prefetchable memory behind bridge: d0000000-d7ffffff BridgeCtl: Parity- SERR- NoISA+ VGA+ MAbort- >Reset- FastB2B- Capabilities: <available only to root>
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40) Subsystem: VIA Technologies, Inc. VT82C686/A PCI to ISA Bridge Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 0 Capabilities: <available only to root>
00:07.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP]) Subsystem: VIA Technologies, Inc. Bus Master IDE Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 64 Region 4: I/O ports at d000 [size=16] Capabilities: <available only to root>
00:07.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) (prog-if 00 [UHCI]) Subsystem: Unknown device 0925:1234 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, cache line size 08 Interrupt: pin D routed to IRQ 5 Region 4: I/O ports at d400 [size=32] Capabilities: <available only to root>
00:07.3 USB Controller: VIA Technologies, Inc. UHCI USB (rev 16) (prog-if 00 [UHCI]) Subsystem: Unknown device 0925:1234 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32, cache line size 08 Interrupt: pin D routed to IRQ 5 Region 4: I/O ports at d800 [size=32] Capabilities: <available only to root>
00:07.4 Bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40) Subsystem: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] Control: I/O- Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Interrupt: pin ? routed to IRQ 9 Capabilities: <available only to root>
00:07.5 Multimedia audio controller: VIA Technologies, Inc. AC97 Audio Controller (rev 50) Subsystem: VIA Technologies, Inc.: Unknown device 7911 Control: I/O+ Mem- BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Interrupt: pin C routed to IRQ 10 Region 0: I/O ports at dc00 [size=256] Region 1: I/O ports at e000 [size=4] Region 2: I/O ports at e400 [size=4] Capabilities: <available only to root>
00:08.0 Ethernet controller: Lite-On Communications Inc LNE100TX [Linksys EtherFast 10/100] (rev 25) Subsystem: Lite-On Communications Inc: Unknown device c001 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B- Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (2000ns min, 14000ns max), cache line size 08 Interrupt: pin A routed to IRQ 11 Region 0: I/O ports at ec00 [size=256] Region 1: Memory at df000000 (32-bit, non-prefetchable) [size=256] Expansion ROM at <unassigned> [disabled] [size=64K] Capabilities: <available only to root>
01:00.0 VGA compatible controller: ATI Technologies Inc Radeon QD (prog-if 00 [VGA]) Subsystem: ATI Technologies Inc: Unknown device 0008 Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR- FastB2B- Status: Cap+ 66Mhz+ UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- Latency: 32 (2000ns min), cache line size 08 Interrupt: pin A routed to IRQ 11 Region 0: Memory at d0000000 (32-bit, prefetchable) [size=128M] Region 1: I/O ports at c000 [size=256] Region 2: Memory at dd000000 (32-bit, non-prefetchable) [size=512K] Expansion ROM at <unassigned> [disabled] [size=128K] Capabilities: <available only to root>
Let me know if you need any more info..
-- "I think a lot of the basis of the open source movement comes from procrastinating students..." -- Andrew Tridgell <http://www.linux-mag.com/2001-07/tridgell_04.html> - To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html Please read the FAQ at http://www.tux.org/lkml/
| |