Messages in this thread | | | Date | Sun, 02 Jul 2000 14:34:01 -0300 | From | Marcelo de Paula Bezerra <> | Subject | Re: Vojtech's via82cxxx.c failure report. |
| |
Mark Hahn wrote: > > > Andre's code with via tunning enabled fails as well, and without tunnig > > will let the drive as UDMA33 with only ocasional BadCRC messages... > > > > hdb: dma_intr: status=0x51 { DriveReady SeekComplete Error } > > hdb: dma_intr: error=0x84 { DriveStatusError BadCRC } > > just checking: you know that this is completely expected, normal > and good behavior and indicates that your cabling is marginal? > (failed CRC's just signal that the controller+drive have detected > a corrupted transmission, and Linux will automatically retry. > you can make them go away if you fix your cabling. ide cabling > must be <= 18", with both ends plugged in, master/slave 6" apart. > you can use the much-higher-quality udma66 cable (80 conductor) > for all other modes of IDE to improve signal quality.)
I really would enjoy to change my cable to the 80conductor type, but it is just not an option, you just can't find it where I live and import fee's are as high as 60% and they do afect shipment costs as well.
This cable was used win UDMA33 sucessfuly on my old mother board that died due to oxidation, it was based on SiS5513(el cheapo mb from www.pcchips.com.tw) now I replaced it with a Soyo 5EH v1.2 and it complains a lot.
-- -----BEGIN GEEK CODE BLOCK----- Version: 3.1 GCM/CS/CC/E/IT/O d--- s: a-- C++++ UL++++ UB->++++ P L++++ E---- W+ K? w--- PS+++ t+++ X+ D+ G e>++ h! y++>+++++$ ------END GEEK CODE BLOCK------
Tekmetrics certified Master Linux Administrator http://www.tekmetrics.com/transcript.jsp?pid=97219
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |