Messages in this thread | | | Date | Wed, 21 Jul 1999 18:04:01 +0000 | From | Bruce Korb <> | Subject | Multiple Problems |
| |
Hi,
I have loaded the S.u.S.E. 6.1 distribution. I have both an IDE and a SCSI disk on an Adaptec 2940 controller. The BIOS can see the controller and identifies the disk just fine. Linux cannot see it. Supposedly, the aic7xxx driver should work with it..... Meanwhile, I dual boot by going into the BIOS and changing the primary boot device from IDE to SCSI and back...
Also, I have a relatively new Iomega parport zip drive. Despite loading the parport driver, neither the imm driver (which I think is the right one) nor the ppa driver will load. They complain of the port being busy. There is nothing on it that I know about. The HOWTOs were not too helpful. One mentioned that a certain message meant that SCSI was loaded but could not see anything. I got that message, but the HOWTO did not say what to do about it :-(.
Help, please? :)
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |