Messages in this thread | | | Date | Wed, 28 Apr 1999 21:48:13 -0400 | From | Timothy Wood <> | Subject | no interrupts to 3c509B |
| |
Hallo, I am getting no interrupts to my ethernet, a 3com 3c509B, so it's not receiving any packets. The loopback works fine and the ethernet seems to transmit according to ifconfig, but there is no receive activity. Here's a dmesg output and some other info. By the way, I have the latest release of nettools also and need any reply CCd to me because I'm not subscribed. Thanks!
Timothy,
Fresh Install of Slackware 3.6 SuperMicro P6SBA mobo with AMI winBIOS (nolaughing) 1.5b (latest) PII 350 128MB PC100 SDRAM IBM 1.6GB IDE - primary slave Maxtor 7GB IDE - primary master Teac 32X CDrom - secondary master Mitsumi 32X CDrom - seconadry slave 3com 3c509B (no problems until new mobo) STB V4400 Pci gen Pci soundcard with Vortex1 chipset 33.6 modem ISA
Linux version 2.2.6 (root@ziggy) (gcc version 2.7.2.3) #7 Wed Apr 28 21:04:51 EDT 1999 Detected 350804336 Hz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 349.80 BogoMIPS Memory: 128220k/131072k available (888k kernel code, 412k reserved, 1516k data, 36k init) CPU: Intel Pentium II (Deschutes) stepping 01 Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.26 (19981001) Richard Gooch (rgooch@atnf.csiro.au) PCI: PCI BIOS revision 2.10 entry at 0xfdb81 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Enabling I/O for device 00:3a Linux NET4.0 for Linux 2.2 Based upon Swansea University Computer Society NET3.039 NET4: Unix domain sockets 1.0 for Linux NET4.0. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP Starting kswapd v 1.5 Detected PS/2 Mouse Port. Serial driver version 4.27 with no serial options enabled ttyS00 at 0x03f8 (irq = 4) is a 16550A ttyS01 at 0x02f8 (irq = 3) is a 16550A pty: 256 Unix98 ptys configured Real Time Clock Driver v1.09 PIIX4: IDE controller on PCI bus 00 dev 39 PIIX4: not 100% native mode: will probe irqs later ide0: BM-DMA at 0xffa0-0xffa7, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xffa8-0xffaf, BIOS settings: hdc:DMA, hdd:DMA hda: Maxtor 90720D5, ATA DISK drive hdb: IBM-DJAA-31700, ATA DISK drive hdc: CD-532E-A, ATAPI CDROM drive hdd: FX320S, ATAPI CDROM drive ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 hda: Maxtor 90720D5, 6869MB w/256kB Cache, CHS=875/255/63, UDMA hdb: IBM-DJAA-31700, 1628MB w/96kB Cache, CHS=827/64/63, DMA hdc: ATAPI 32X CD-ROM drive, 128kB Cache Uniform CDROM driver Revision: 2.54 hdd: ATAPI 32X CD-ROM drive, 256kB Cache Floppy drive(s): fd0 is 1.44M FDC 0 is a post-1991 82077 PPP: version 2.3.3 (demand dialling) TCP compression code copyright 1989 Regents of the University of California PPP line discipline registered. eth0: 3c509 at 0x280 tag 1, 10baseT port, address 00 a0 24 1f 32 02, IRQ 9. 3c509.c:1.16 (2.2) 2/3/98 becker@cesdis.gsfc.nasa.gov. Partition check: hda: hda1 hda2 hda3 hdb: hdb1 VFS: Mounted root (ext2 filesystem) readonly. Freeing unused kernel memory: 36k freed eth0: Setting Rx mode to 1 addresses.
eth0 Link encap:Ethernet HWaddr 00:A0:24:1F:32:02 inet addr:10.0.10.75 Bcast:10.255.255.255 Mask:255.0.0.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:22 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100 Interrupt:9 Base address:0x280
lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:3924 Metric:1 RX packets:40 errors:0 dropped:0 overruns:0 frame:0 TX packets:40 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0
CPU0 0: 5367 XT-PIC timer 1: 282 XT-PIC keyboard 2: 0 XT-PIC cascade 8: 1 XT-PIC rtc 9: 0 XT-PIC eth0 12: 0 XT-PIC PS/2 Mouse 13: 1 XT-PIC fpu 14: 1723 XT-PIC ide0 15: 12 XT-PIC ide1 NMI: 0
Kernel IP routing table Destination Gateway Genmask Flags Metric Ref Use Iface 10.0.0.0 10.0.10.75 255.0.0.0 UG 0 0 0 eth0 10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 eth0 10.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 10.0.0.1 0.0.0.0 UG 1 0 0 eth0
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |