lkml.org 
[lkml]   [1999]   [Oct]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: 2.2.13 can't see my ide hd; dmesg sent correctly
	From: Joshua Lambert <jlambert@m-net.arbornet.org>

PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide1: BM-DMA at 0x1408-0x140f, BIOS settings: hdc:pio, hdd:pio
hdc: R/RW 4x4x24, ATAPI CDROM drive
hdd: IOMEGA ZIP 100 ATAPI, ATAPI FLOPPY drive
ide1 at 0x170-0x177,0x376 on irq 15
hdc: ATAPI 24X CD-ROM CD-R/RW drive, 2048kB Cache
Uniform CDROM driver Revision: 2.56
hdd: 98304kB, 96/64/32 CHS, 4096 kBps, 512 sector size, 2941 rpm
hdd: The drive reports both 100663296 and 0 bytes as its capacity
Floppy drive(s): fd0 is 1.44M

Uhhuh. NMI received. Dazed and confused, but trying to continue
You probably have a hardware problem with your RAM chips

I would be worried by this. Check whether your memory is OK.

kmod: failed to exec /sbin/modprobe -s -k block-major-3, errno = 2

And you are not building your system with ide as a module where the
module has to be loaded from IDE disk?

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.rutgers.edu
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:54    [W:0.031 / U:0.864 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site