Messages in this thread | | | Date | Fri, 1 Oct 1999 08:32:07 +0100 (BST) | From | Tigran Aivazian <> | Subject | 2.3.19-pre1 - two problems, or even three. |
| |
Hi,
0. The Makefile still says it is 2.3.18.
1. The line 72 of drivers/char/Config.in still needs a ']'
2. On Compaq Proliant 1600 (dual PII/400) it still does not boot. See bootlog captured via serial console below with SMP_DEBUG on. Note that 2.3.14 and earlier work fine.
Regards, ------ Tigran A. Aivazian | http://www.sco.com Escalations Research Group | tel: +44-(0)1923-813796 Santa Cruz Operation Ltd | http://www.ocston.org/~tigran
Linux version 2.3.18 (root@elisha.london.sco.com) (gcc version egcs-2.91.66 19990314/Linux (egcs-1.1.2 release)) #3 SMP Fri Oct 1 09:21:48 BST 1999 e820: 653312 @ 00000000 (usable) e820: 2048 @ 0009f800 (reserved) e820: 65536 @ 000f0000 (reserved) e820: 66060288 @ 00100000 (usable) e820: 65536 @ fec00000 (reserved) e820: 65536 @ fee00000 (reserved) e820: 524288 @ fff80000 (reserved) e820: 0 @ 00000000 (usable) Scan SMP from c0000000 for 1024 bytes. Scan SMP from c009fc00 for 1024 bytes. Scan SMP from c00f0000 for 65536 bytes. Intel MultiProcessor Specification v1.4 Virtual Wire compatibility mode. OEM ID: COMPAQ Product ID: PROLIANT APIC at: 0xFEE00000 Processor #1 Pentium(tm) Pro APIC version 16 Floating point unit present. Machine Exception supported. 64 bit compare & exchange supported. Internal APIC present. Bootup CPU Processor #0 Pentium(tm) Pro APIC version 16 Floating point unit present. Machine Exception supported. 64 bit compare & exchange supported. Internal APIC present. Bus #0 is PCI Bus #1 is PCI Bus #9 is ISA I/O APIC #8 Version 17 at 0xFEC00000. Processors: 2 mapped APIC to ffffe000 (fee00000) mapped IOAPIC to ffffd000 (fec00000) Detected 399076003 Hz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 398.13 BogoMIPS memory region: 638k @ 00000000 memory region: 64512k @ 00100000 Memory: 62824k/65536k available (872k kernel code, 432k reserved, 1328k data, 80k init, 0k bigmem) Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes) Page-cache hash table entries: 16384 (order: 4, 65536 bytes) Checking 386/387 coupling... OK, FPU using exception 16 error reporting. Checking 'hlt' instruction... OK. POSIX conformance testing by UNIFIX mtrr: v1.35 (19990512) Richard Gooch (rgooch@atnf.csiro.au) per-CPU timeslice cutoff: 100.01 usecs. CPU1: Intel Pentium II (Deschutes) stepping 01 Getting VERSION: 40011 Getting VERSION: 40011 Getting LVT0: 700 Getting LVT1: 400 setup_APIC_clock() called. calibrating APIC timer ... ..... 3990924 CPU clocks in 1 timer chip tick. .... 997729 APIC bus clocks in 1 timer chip tick. ..... CPU clock speed is 399.0924 MHz. ..... system bus clock speed is 99.7729 MHz. CPU map: 3 Booting processor 0 eip 2000 Setting warm reset code and vector. 1. 2. 3. Asserting INIT. Deasserting INIT. Sending STARTUP #1. After apic_write. Before start apic_write. Startup point 1. Initializing CPU#0 Waiting for send to finish... CPU#0 waiting for CALLOUT +Sending STARTUP #2. After apic_write. Before start apic_write. Startup point 1. Waiting for send to finish... +After Startup. Before Callout 0. After Callout 0. CALLIN, before enable_local_APIC(). setup_APIC_clock() called. waiting for other CPU calibrating APIC ... done, continuing. Calibrating delay loop... 398.95 BogoMIPS Stack at about c0343fbc OK. CPU0: Intel Pentium II (Deschutes) stepping 01 CPU has booted. Before bogomips. Total of 2 processors activated (797.08 BogoMIPS). Before bogocount - setting activated=1. Boot done. enabling symmetric IO mode... ...done. ENABLING IO-APIC IRQs init IO_APIC IRQs IO-APIC (apicid-pin) 8-0, 8-16, 8-17, 8-18, 8-19, 8-20, 8-21, 8-22, 8-23, 8-24, 8-25, 8-26, 8-27, 8-28, 8-29, 8-30, 8-31, 8-32, 8-33, 8-34 not connected. number of MP IRQ sources: 16. number of IO-APIC #8 registers: 35. testing the IO APIC.......................
IO APIC #8...... .... register #00: 00000000 ....... : physical APIC id: 00 .... register #01: 00220011 ...... : max redirection entries: 0022 WARNING: unexpected IO-APIC, please mail to linux-smp@vger.rutgers.edu ....... : IO APIC version: 0011 .... register #02: 00000000 ....... : arbitration: 00 .... IRQ redirection table: NR Log Phy Mask Trig IRR Pol Stat Dest Deli Vect: 00 000 00 1 0 0 0 0 0 0 00 01 000 00 0 0 0 0 0 1 1 59 02 0FF 0F 0 0 0 0 0 1 1 51 03 000 00 0 0 0 0 0 1 1 61 04 000 00 0 0 0 0 0 1 1 69 05 0FF 0F 1 1 0 0 0 1 1 71 06 000 00 0 0 0 0 0 1 1 79 07 000 00 0 0 0 0 0 1 1 81 08 000 00 0 0 0 0 0 1 1 89 09 0FF 0F 1 1 0 0 0 1 1 91 0a 0FF 0F 1 1 0 0 0 1 1 99 0b 0FF 0F 1 1 0 0 0 1 1 A1 0c 000 00 0 0 0 0 0 1 1 A9 0d 000 00 1 0 0 0 0 0 0 00 0e 000 00 0 0 0 0 0 1 1 B1 0f 0FF 0F 1 1 0 0 0 1 1 B9 10 000 00 1 0 0 0 0 0 0 00 11 000 00 1 0 0 0 0 0 0 00 12 000 00 1 0 0 0 0 0 0 00 13 000 00 1 0 0 0 0 0 0 00 14 000 00 1 0 0 0 0 0 0 00 15 000 00 1 0 0 0 0 0 0 00 16 000 00 1 0 0 0 0 0 0 00 17 000 00 1 0 0 0 0 0 0 00 18 000 00 1 0 0 0 0 0 0 00 19 000 00 1 0 0 0 0 0 0 00 1a 000 00 1 0 0 0 0 0 0 00 1b 000 00 1 0 0 0 0 0 0 00 1c 000 00 1 0 0 0 0 0 0 00 1d 000 00 1 0 0 0 0 0 0 00 1e 000 00 1 0 0 0 0 0 0 00 1f 000 00 1 0 0 0 0 0 0 00 20 000 00 1 0 0 0 0 0 0 00 21 000 00 1 0 0 0 0 0 0 00 22 000 00 1 0 0 0 0 0 0 00 .................................... done. Initializing CPU#1 Setting commenced=1, go go go mtrr: your CPUs had inconsistent fixed MTRR settings mtrr: probably your BIOS does not setup all CPUs PCI: PCI BIOS revision 2.10 entry at 0xf0080 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: Assigned I/O space 1000-101f to device Intel 82371AB PIIX4 USB PCI: Enabling I/O for device Intel 82371AB PIIX4 USB PCI: Device 00:00 not found by BIOS PCI: Device 00:a0 not found by BIOS PCI: Device 00:a1 not found by BIOS PCI: Device 00:a2 not found by BIOS PCI: Device 00:a3 not found by BIOS Linux NET4.0 for Linux 2.3 Based upon Swansea University Computer Society NET3.039 NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. NET4: Linux TCP/IP 1.0 for NET4.0 IP Protocols: ICMP, UDP, TCP TCP: Hash tables configured (established 2048 bind 4096) Starting kswapd v1.6 Detected PS/2 Mouse Port. Ser
on the real console I see the end of the last sentence as well, i.e.
"Serial driver version 4.30 with_"
(I showed blinking cursor as _)
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |