Messages in this thread | | | Date | Sun, 10 Jan 1999 02:51:06 -0800 | From | Sang Kang <> | Subject | Re: 2.2.0pre5: parport as module |
| |
On Fri, Jan 08, 1999 at 08:10:54PM -0600, Brian Ryner wrote: > Hi- > > I think I've seen similar reports to this on the list before, but I > never noticed any resolution to it. Anyway, my problem is that my > printing works fine if I compile the parallel port support into the > kernel, but not if I compile it as a module (parport.o + parport_pc.o). > When I compile it as a module, the module autoloads when necessary, but > lpq still reports that the printer is offline. It's definitely one of > these modules causing it, as I have lp.o as a module in both cases. > Anyone know why this would happen? >
I believe there is a documentation in the source code somewhere, but anyway, here's my parport entry in /etc/conf.modules. HTH,
alias parport_lowlevel parport_pc options parport_pc io=0x378,0x278 irq=7,auto
Sang Kang
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |