lkml.org 
[lkml]   [2024]   [Apr]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 2/4] serial: amba-pl011: move variable into CONFIG_DMA_ENGINE conditional
Date
Variable dmacr is only used if DMA is enabled, so move it into the
CONFIG_DMA_ENGINE conditional.

Signed-off-by: Lino Sanfilippo <l.sanfilippo@kunbus.com>
---
drivers/tty/serial/amba-pl011.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/tty/serial/amba-pl011.c b/drivers/tty/serial/amba-pl011.c
index 3d2dac0ebcde..349005e6ab9f 100644
--- a/drivers/tty/serial/amba-pl011.c
+++ b/drivers/tty/serial/amba-pl011.c
@@ -256,7 +256,6 @@ struct uart_amba_port {
const u16 *reg_offset;
struct clk *clk;
const struct vendor_data *vendor;
- unsigned int dmacr; /* dma control reg */
unsigned int im; /* interrupt mask */
unsigned int old_status;
unsigned int fifosize; /* vendor-specific */
@@ -266,6 +265,7 @@ struct uart_amba_port {
unsigned int rs485_tx_drain_interval; /* usecs */
#ifdef CONFIG_DMA_ENGINE
/* DMA stuff */
+ unsigned int dmacr; /* dma control reg */
bool using_tx_dma;
bool using_rx_dma;
struct pl011_dmarx_data dmarx;
--
2.43.2
\
 
 \ /
  Last update: 2024-05-27 16:27    [W:0.046 / U:0.300 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site