lkml.org 
[lkml]   [2024]   [Apr]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 2/2] arm64: dts: rockchip: Add Radxa ZERO 3W/3E
From
Hi Krzysztof,

On 2024-04-14 15:33, Krzysztof Kozlowski wrote:
> On 14/04/2024 15:15, Jonas Karlman wrote:
>> The Radxa ZERO 3W/3E is an ultra-small, high-performance single board
>> computer based on the Rockchip RK3566, with a compact form factor and
>> rich interfaces.
>>
>> The ZERO 3W and ZERO 3E are basically the same size and model, but
>> differ only in storage and network interfaces.
>>
>> - eMMC (3W)
>> - SD-card (both)
>> - Ethernet (3E)
>> - WiFi/BT (3W)
>>
>> This adds initial support for eMMC, SD-card, Ethernet, HDMI and USB.
>>
>> Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
>> ---
>> .../dts/rockchip/rk3566-radxa-zero-3e.dts | 41 ++
>> .../dts/rockchip/rk3566-radxa-zero-3w.dts | 26 +
>> .../boot/dts/rockchip/rk3566-radxa-zero3.dtsi | 443 ++++++++++++++++++
>> 3 files changed, 510 insertions(+)
>
> How do you build your patches? That's rhetorical, because they cannot be
> built... Missing Makefile.

They where built using the generic .dtb-file make target, will include
in Makefile in v2, thanks.

>
> Are you sure therefore that your dts pass dtbs_check? If this is not in
> Makefile, how did you run the command?

I built and tested dts files using the following make commands:

make CROSS_COMPILE=aarch64-linux-gnu- ARCH=arm64 defconfig
make CROSS_COMPILE=aarch64-linux-gnu- ARCH=arm64 CHECK_DTBS=y rockchip/rk3566-radxa-zero-3w.dtb
make CROSS_COMPILE=aarch64-linux-gnu- ARCH=arm64 CHECK_DTBS=y rockchip/rk3566-radxa-zero-3e.dtb

Regards,
Jonas

>
> Best regards,
> Krzysztof
>


\
 
 \ /
  Last update: 2024-05-27 16:40    [W:0.033 / U:0.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site