lkml.org 
[lkml]   [2024]   [Mar]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[PATCH v3 3/3] spi: omap2-mcpsi: Enable MULTI-mode in more situations
Enable multimode when a transfer of multiple small words can be
transformed in a transfer with a single bigger word. This is allowed as
long as the result on the cable is the same, so word_delay must be zero.

Signed-off-by: Louis Chauvet <louis.chauvet@bootlin.com>

---

I am not sure if this is the best place to put such "optimization". I
think this improvment should be in the core, as it is not depending on the
driver itself, but I think Mark suggested something like this so if that
fits to what was expected, I am happy to share this small improvement.
---
drivers/spi/spi-omap2-mcspi.c | 15 ++++++++++++++-
1 file changed, 14 insertions(+), 1 deletion(-)

diff --git a/drivers/spi/spi-omap2-mcspi.c b/drivers/spi/spi-omap2-mcspi.c
index 002f29dbcea6..7e3083b83534 100644
--- a/drivers/spi/spi-omap2-mcspi.c
+++ b/drivers/spi/spi-omap2-mcspi.c
@@ -1277,11 +1277,24 @@ static int omap2_mcspi_prepare_message(struct spi_controller *ctlr,

/*
* Check if this transfer contains only one word;
+ * OR contains 1 to 4 words, with bits_per_word == 8 and no delay between each word
+ * OR contains 1 to 2 words, with bits_per_word == 16 and no delay between each word
+ *
+ * If one of the two last case is true, this also change the bits_per_word of this
+ * transfer to make it a bit faster.
+ * It's not an issue to change the bits_per_word here even if the multi-mode is not
+ * applicable for this message, the signal on the wire will be the same.
*/
if (bits_per_word < 8 && tr->len == 1) {
/* multi-mode is applicable, only one word (1..7 bits) */
+ } else if (tr->word_delay.value == 0 && bits_per_word == 8 && tr->len <= 4) {
+ /* multi-mode is applicable, only one "bigger" word (8,16,24,32 bits) */
+ tr->bits_per_word = tr->len * bits_per_word;
+ } else if (tr->word_delay.value == 0 && bits_per_word == 16 && tr->len <= 2) {
+ /* multi-mode is applicable, only one "bigger" word (16,32 bits) */
+ tr->bits_per_word = tr->len * bits_per_word / 2;
} else if (bits_per_word >= 8 && tr->len == bits_per_word / 8) {
- /* multi-mode is applicable, only one word (8..32 bits) */
+ /* multi-mode is applicable, only one word (9..15,17..32 bits) */
} else {
/* multi-mode is not applicable: more than one word in the transfer */
mcspi->use_multi_mode = false;
--
2.43.0


\
 
 \ /
  Last update: 2024-05-27 16:10    [W:0.047 / U:3.320 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site