lkml.org 
[lkml]   [2024]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 3/8] ARM: dts: microchip: sama5d27_som1_ek: Add power-supply properties for sdmmc nodes
Date
The sdmmc0 and sdmmc1 controllers are powered from 3.3V regulator.
Add vmmc-supply and vqmmc-supply properties to sdmmc nodes.
The sdmmc controller from SAMA5D2 MPU has support for
IO voltage signaling/switching required by the UHS sd-card.
In order to avoid the issues from the tuning procedure required by
the UHS cards, keep the vqmmc at 3V3 to use the sd high-speed mode.

Signed-off-by: Mihai Sain <mihai.sain@microchip.com>
---
arch/arm/boot/dts/microchip/at91-sama5d27_som1_ek.dts | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/arch/arm/boot/dts/microchip/at91-sama5d27_som1_ek.dts b/arch/arm/boot/dts/microchip/at91-sama5d27_som1_ek.dts
index f3ffb8f01d8a..255ee0640133 100644
--- a/arch/arm/boot/dts/microchip/at91-sama5d27_som1_ek.dts
+++ b/arch/arm/boot/dts/microchip/at91-sama5d27_som1_ek.dts
@@ -56,6 +56,8 @@ sdmmc0: sdio-host@a0000000 {
bus-width = <8>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_sdmmc0_default>;
+ vmmc-supply = <&vddin_3v3>;
+ vqmmc-supply = <&vddin_3v3>;
status = "okay";
};

@@ -63,6 +65,8 @@ sdmmc1: sdio-host@b0000000 {
bus-width = <4>;
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_sdmmc1_default>;
+ vmmc-supply = <&vddin_3v3>;
+ vqmmc-supply = <&vddin_3v3>;
status = "okay";
};

--
2.43.0

\
 
 \ /
  Last update: 2024-05-27 14:50    [W:0.131 / U:0.116 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site