lkml.org 
[lkml]   [2024]   [Feb]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH v1] arm64: dts: ti: verdin-am62: mallow: add TPM device
From
On 1/26/24 10:51 AM, Francesco Dolcini wrote:
> From: Francesco Dolcini <francesco.dolcini@toradex.com>
>
> Add TPM device to Mallow device tree file, the device is connected to
> the SoC with SPI1/CS1, the same SPI interface is also available on an
> extension header together with an additional CS0 signal.
>
> Signed-off-by: Francesco Dolcini <francesco.dolcini@toradex.com>
> ---
> arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi | 10 ++++++++++
> 1 file changed, 10 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi b/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
> index 17b93534f658..77b1beb638ad 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am62-verdin-mallow.dtsi
> @@ -127,6 +127,16 @@ &main_spi1 {
> <&pinctrl_qspi1_cs2_gpio>;
> cs-gpios = <0>, <&main_gpio0 12 GPIO_ACTIVE_LOW>;
> status = "okay";
> +
> + tpm@1 {
> + compatible = "infineon,slb9670", "tcg,tpm_tis-spi";
> + reg = <1>;
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_qspi1_dqs_gpio>;
> + interrupt-parent = <&main_gpio1>;
> + interrupts = <18 IRQ_TYPE_EDGE_FALLING>;

Just a heads-up, the SLB9670 datasheet says this device uses
an active low interrupt (IRQ_TYPE_LEVEL_LOW). Using TYPE_EDGE
here can cause missed interrupts if the line stays low for
multiple interrupts.

Andrew

> + spi-max-frequency = <18500000>;
> + };
> };
>
> /* Verdin UART_3 */

\
 
 \ /
  Last update: 2024-05-27 14:51    [W:0.089 / U:0.124 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site