lkml.org 
[lkml]   [2024]   [Feb]   [5]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/8] ARM: dts: microchip: sam9x60ek: Add power-supply properties for sdmmc nodes
Date
The sdmmc0 and sdmmc1 controllers are powered from 3.3V regulator.
Add vmmc-supply and vqmmc-supply properties to sdmmc nodes.
The sdmmc controller from SAM9X60 MPU doesn't support the IO voltage signaling/switching required by the UHS sd-card.
In order to use the sd high-speed mode, keep vqmmc at 3V3.

Signed-off-by: Mihai Sain <mihai.sain@microchip.com>
---
arch/arm/boot/dts/microchip/at91-sam9x60ek.dts | 4 ++++
1 file changed, 4 insertions(+)

diff --git a/arch/arm/boot/dts/microchip/at91-sam9x60ek.dts b/arch/arm/boot/dts/microchip/at91-sam9x60ek.dts
index f3cbb675cea4..b19a0956dc97 100644
--- a/arch/arm/boot/dts/microchip/at91-sam9x60ek.dts
+++ b/arch/arm/boot/dts/microchip/at91-sam9x60ek.dts
@@ -560,6 +560,8 @@ &sdmmc0 {
status = "okay";
cd-gpios = <&pioA 23 GPIO_ACTIVE_LOW>;
disable-wp;
+ vmmc-supply = <&vdd1_3v3>;
+ vqmmc-supply = <&vdd1_3v3>;
};

&sdmmc1 {
@@ -568,6 +570,8 @@ &sdmmc1 {
pinctrl-0 = <&pinctrl_sdmmc1_default>;
no-1-8-v;
non-removable;
+ vmmc-supply = <&vdd1_3v3>;
+ vqmmc-supply = <&vdd1_3v3>;
status = "disabled"; /* Conflict with flx4. */
};

--
2.43.0

\
 
 \ /
  Last update: 2024-05-27 14:47    [W:0.086 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site