Messages in this thread | | | Date | Wed, 21 Feb 2024 16:04:05 +0530 | Subject | Re: [PATCH 0/5] Add QPIC SPI NAND driver | From | Md Sadre Alam <> |
| |
On 2/20/2024 5:06 PM, Krzysztof Kozlowski wrote: > On 20/02/2024 12:32, Md Sadre Alam wrote: >> >> >> On 2/19/2024 6:34 PM, Manivannan Sadhasivam wrote: >>> On Thu, Feb 15, 2024 at 07:18:51PM +0530, Md Sadre Alam wrote: >>>> This series of patches will add initial supports >>>> for QPIC SPI NAND driver. >>>> >>>> Currently this driver support following commands >>>> >>>> -- RESET >>>> -- READ ID >>>> -- BLOCK ERASE >>>> -- PAGE READ >>>> -- PAGE WRITE >>>> -- GET FEATURE >>>> -- SET FEATURE >>>> -- BAD BLOCK CHECK >>>> >>>> This driver has been tested with dd command with read/write page >>>> with multiple file size 1MiB, 10MiB,40MiB etc. >>>> Also tested with "mtd" command like mtd erase, mtd write, mtd verify etc. >>>> >>> >>> This is not the first version isn't it? Where is the changelog describing what >>> has changed since then? >> >> The earlier patch was the RFC for design review only. > > RFC is state of patch, not version. This is v2 then. > > These RFC postings are really becoming mess. Some people make multiple > RFCs and then post v1 hiding entire previous history... And why even > bother with calling it RFC?
Sorry, I was not aware of this. Shall I post the next one as V3 and add references to the RFC patch and this patch in the cover letter of V3? > > Best regards, > Krzysztof >
| |