Messages in this thread | | | Date | Fri, 2 Feb 2024 12:27:37 +0100 | From | Luca Ceresoli <> | Subject | Re: [PATCH V7 2/2] drm/bridge: imx: add driver for HDMI TX Parallel Video Interface |
| |
On Sat, 6 Jan 2024 15:51:45 -0600 Adam Ford <aford173@gmail.com> wrote:
> From: Lucas Stach <l.stach@pengutronix.de> > > This IP block is found in the HDMI subsystem of the i.MX8MP SoC. It has a > full timing generator and can switch between different video sources. On > the i.MX8MP however the only supported source is the LCDIF. The block > just needs to be powered up and told about the polarity of the video > sync signals to act in bypass mode. > > Signed-off-by: Lucas Stach <l.stach@pengutronix.de> > Reviewed-by: Luca Ceresoli <luca.ceresoli@bootlin.com> (v2) > Tested-by: Marek Vasut <marex@denx.de> (v1) > Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com> (v2) > Tested-by: Richard Leitner <richard.leitner@skidata.com> (v2) > Tested-by: Frieder Schrempf <frieder.schrempf@kontron.de> (v2) > Reviewed-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com> (v3) > Reviewed-by: Luca Ceresoli <luca.ceresoli@bootlin.com> > Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com> > Tested-by: Fabio Estevam <festevam@gmail.com> > Signed-off-by: Adam Ford <aford173@gmail.com>
On v6.8-rc1, custom hardware based on the Avnet i.MX8MP SMARC SoM.
Tested-by: Luca Ceresoli <luca.ceresoli@bootlin.com>
I think you can remove the Tested-by I sent for previous versions.
Luca
-- Luca Ceresoli, Bootlin Embedded Linux and Kernel engineering https://bootlin.com
| |