lkml.org 
[lkml]   [2024]   [Feb]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 0/4] arm64: dts: ti: Modify pinmux for wkup_uart0 and mcu_uart0
From
This should have been a v2, please ignore this . I will resend.

Thanks

On 12/02/24 3:29 pm, Bhavya Kapoor wrote:
> WKUP_PADCONFIG registers for wkup_uart0 and mcu_uart0 lies under
> wkup_pmx2 for J7200. Thus, modify pinmux for both of them. Also,
> remove the redundant clock-frequency property from mcu_uart0 node.
>
> Only Tx and Rx Signal lines for wkup_uart0 are brought out on
> J721S2 Common Proc Board and J784S4 EVM, but CTS and RTS signal lines
> are not brought out. Thus, remove pinmux for CTS and RTS signal lines
> for wkup_uart0 in J721S2 and J784S4.
>
> Bhavya Kapoor (4):
> arm64: dts: ti: k3-j7200-common-proc-board: Modify Pinmux for
> wkup_uart0 and mcu_uart0
> arm64: dts: ti: k3-j7200-common-proc-board: Remove clock-frequency
> from mcu_uart0
> arm64: dts: ti: k3-j721s2-common-proc-board: Remove Pinmux for CTS and
> RTS in wkup_uart0
> arm64: dts: ti: k3-j784s4-evm: Remove Pinmux for CTS and RTS in
> wkup_uart0
>
> .../boot/dts/ti/k3-j7200-common-proc-board.dts | 18 +++++++++---------
> .../dts/ti/k3-j721s2-common-proc-board.dts | 2 --
> arch/arm64/boot/dts/ti/k3-j784s4-evm.dts | 2 --
> 3 files changed, 9 insertions(+), 13 deletions(-)
>

\
 
 \ /
  Last update: 2024-05-27 14:57    [W:0.045 / U:0.824 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site