lkml.org 
[lkml]   [2024]   [Jan]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 2/3] dt-bindings: fpga: xlnx,fpga-slave-selectmap: add DT schema
From
Hello Krzysztof,

On 30/01/2024 16:09, Krzysztof Kozlowski wrote:

>> +
>> +description: |
>> + Xilinx 7 Series FPGAs support a method of loading the bitstream over a
>> + parallel port named the slave SelectMAP interface in the documentation. Only
>> + the x8 mode is supported where data is loaded at one byte per rising edge of
>> + the clock, with the MSB of each byte presented to the D0 pin.
>> +
>> + Datasheets:
>> + https://www.xilinx.com/support/documentation/user_guides/ug470_7Series_Config.pdf
>
> I am surprised that AMD/Xilinx still did not update the document to
> modern naming (slave->secondary).

Thank you for bringing this up.

We are moving away from using non-inclusive technical terminology and
are removing non-inclusive language from our products and related
collateral. You will for some time find examples of non-inclusive
language, especially in our older products as we work to make these
changes and align with industry standards. For new IP we're ensuring
that we switch and stick to inclusive terminology, as you may have seen
with my recent w1 driver submission.

SelectMAP is a decades-old interface and as such it is unlikely that we
will update this in all documentation dating back this time. I shall
however look to understand what is planned here for active documentation
and new driver submissions.

regards
Kris

\
 
 \ /
  Last update: 2024-05-27 14:41    [W:0.086 / U:1.132 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site