lkml.org 
[lkml]   [2023]   [Sep]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH] arm64: dts: qcom: qcm6490-fairphone-fp5: Enable UFS
From
On 29.09.2023 11:52, Luca Weiss wrote:
> Enable the UFS phy and controller so that we can access the internal
> storage of the phone.
>
> At the same time we need to bump the minimum voltage used for UFS VCC,
> otherwise it doesn't initialize properly. The new range is taken from
> the vcc-voltage-level property downstream.
>
> See also the following link for more information about the VCCQ/VCCQ2:
> https://gerrit-public.fairphone.software/plugins/gitiles/kernel/msm-extra/devicetree/+/1590a3739e7dc29d2597307881553236d492f188/fp5/yupik-idp-pm7250b.dtsi#207
>
> Signed-off-by: Luca Weiss <luca.weiss@fairphone.com>
> ---
> I'm not 100% convinced about the regulator range change. For sure with
> the original voltage range the UFS fails to initialize, but looking at
> downstream kernel during runtime (debugfs) we see the VCC voltage
> switches between 2.4V (idle?) and 2.952V (active?). But even with this
> change in mainline the regulator would always stay at 2.504V which is
> for sure lower than the downstream operating voltage of 2.952V. Behavior
> wise I don't see a difference between ~2.5V and ~2.9V.
>
> Should I just constrain the regulator here to min=max=2.952V? Or just
> say it's okay as-is?
>
> Depends on: https://lore.kernel.org/linux-arm-msm/20230927081858.15961-1-quic_nitirawa@quicinc.com/
> ---
There's a little funny hack inside the driver

#if defined(CONFIG_SCSI_UFSHCD_QTI)
if (vreg->low_voltage_sup && !vreg->low_voltage_active && on)
min_uV = vreg->max_uV;
#endif

so, when the ufs is in use, it's pinned to vmax

Konrad

\
 
 \ /
  Last update: 2023-09-29 15:13    [W:5.636 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site