lkml.org 
[lkml]   [2023]   [Aug]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH RESEND] tty: serial: qcom-geni-serial: Poll primary sequencer irq status after cancel_tx
From
Hi,

Thank you very much for the review...


On 8/9/2023 6:49 PM, Hugo Villeneuve wrote:
> On Wed, 9 Aug 2023 17:41:40 +0530
> Vijaya Krishna Nivarthi <quic_vnivarth@quicinc.com> wrote:
>
>> TX is handled by primary sequencer. After cancelling primary command, poll
>> primary sequencer's irq status instead of that of secondary.
> Hi,
> it is not clear to me if this is a bug fix or an improvement?
This is a bug fix.
>
>> While at it, also remove a couple of redundant lines that read from IRQ_EN
>> register and write back same.
> This should go into a separate patch.

The changes were too close by so I wasn't sure it could be split into 2
patches.

I see that the earlier patch has already been signed off by Greg. (I did
a RESEND after realising that I had Bjorn Andersson's email address
incorrect)

Will post another version if original patch doesn't get merged for any
reason.

Thank you,

Vijay/


>
> Hugo Villeneuve.
>
>
>> Fixes: 2aaa43c70778 ("tty: serial: qcom-geni-serial: add support for serial engine DMA")
>> Signed-off-by: Vijaya Krishna Nivarthi <quic_vnivarth@quicinc.com>
>> ---
>> drivers/tty/serial/qcom_geni_serial.c | 7 ++-----
>> 1 file changed, 2 insertions(+), 5 deletions(-)
>>
>> diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
>> index 3ca5db2..b8aa4c1 100644
>> --- a/drivers/tty/serial/qcom_geni_serial.c
>> +++ b/drivers/tty/serial/qcom_geni_serial.c
>> @@ -591,7 +591,6 @@ static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
>> {
>> struct qcom_geni_serial_port *port = to_dev_port(uport);
>> bool done;
>> - u32 m_irq_en;
>>
>> if (!qcom_geni_serial_main_active(uport))
>> return;
>> @@ -603,12 +602,10 @@ static void qcom_geni_serial_stop_tx_dma(struct uart_port *uport)
>> port->tx_remaining = 0;
>> }
>>
>> - m_irq_en = readl(uport->membase + SE_GENI_M_IRQ_EN);
>> - writel(m_irq_en, uport->membase + SE_GENI_M_IRQ_EN);
>> geni_se_cancel_m_cmd(&port->se);
>>
>> - done = qcom_geni_serial_poll_bit(uport, SE_GENI_S_IRQ_STATUS,
>> - S_CMD_CANCEL_EN, true);
>> + done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,
>> + M_CMD_CANCEL_EN, true);
>> if (!done) {
>> geni_se_abort_m_cmd(&port->se);
>> done = qcom_geni_serial_poll_bit(uport, SE_GENI_M_IRQ_STATUS,
>> --
>> 2.7.4
>>

\
 
 \ /
  Last update: 2023-08-09 19:23    [W:0.043 / U:0.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site