lkml.org 
[lkml]   [2023]   [Aug]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 4/6] clk: qcom: Use HW_CTRL_TRIGGER flag to switch video GDSC to HW mode
On 23-08-16 19:56:46, Konrad Dybcio wrote:
> On 16.08.2023 16:57, Abel Vesa wrote:
> > From: Jagadeesh Kona <quic_jkona@quicinc.com>
> >
> > The current HW_CTRL flag switches the video GDSC to HW control mode as
> > part of GDSC enable itself, instead of that use HW_CTRL_TRIGGER flag to
> > give consumer drivers more control and switch the GDSC mode as and when
> > required.
> >
> > HW_CTRL_TRIGGER flag allows consumer drivers to switch the video GDSC to
> > HW/SW control modes at runtime using dev_pm_genpd_set_hwmode API.
> >
> > Signed-off-by: Jagadeesh Kona <quic_jkona@quicinc.com>
> > Signed-off-by: Abel Vesa <abel.vesa@linaro.org>
> > ---
> Do we have any use for the HW_CTRL flag?
>
> Perhaps it should be renamed to HW_CTRL_ALWAYS?
>
> Or even better, *if and only if* that is necessary, add a common
> property like "always_hw_managed" to the genpd code?

The HW_CTRL flag is still needed for the consumers that expect the GDSC
to be have the HW control bit set right after it gets enabled.

AFAIU, for the HW_CTRL_TRIGGER, the switch to HW control will only be
done by the consumer (not on enable).

>
> Konrad

\
 
 \ /
  Last update: 2023-08-23 12:43    [W:0.141 / U:0.408 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site