Messages in this thread | | | Date | Mon, 14 Aug 2023 09:38:03 +0200 | From | neil.armstrong@linaro ... | Subject | Re: [PATCH V2 0/3] Add binding header file for GPIO interrupt of Amlogic Meson-G12A |
| |
On 07/08/2023 15:37, Linus Walleij wrote: > On Mon, Jul 24, 2023 at 8:02 AM Huqiang Qin <huqiang.qin@amlogic.com> wrote: > >> After adding this binding header file, you can intuitively find >> the interrupt number corresponding to each GPIO, and apply it >> in the format of IRQID_XXX where it needs to be used. > (...) > >> Huqiang Qin (3): >> dt-bindings: interrupt-controller: Add header file for Amlogic >> Meson-G12A SoCs >> pinctrl: Replace the IRQ number in the driver with the IRQID macro >> definition >> arm64: dts: Replace the IRQ number with the IRQID macro definition > > Neil wrote: >> What's the best way to apply this patchset ? > > I just applied all three to the pin control tree. > > I could have applied just the two first and then offered an > immutable branch. But eh... too much work for too low risk. > Better to just apply it and hope all works out. If it explodes > I just back out and figure something like the above.
Perfect, thx :-)
Neil
> > Yours, > Linus Walleij
| |